Search results
Results from the WOW.Com Content Network
A minute of arc, arcminute (arcmin), arc minute, or minute arc, denoted by the symbol ′, is a unit of angular measurement equal to 1 / 60 of one degree. [1] Since one degree is 1 / 360 of a turn, or complete rotation, one arcminute is 1 / 21 600 of a turn.
A millisecond (from milli-and second; symbol: ms) is a unit of time in the International System of Units equal to one thousandth (0.001 or 10 −3 or 1 / 1000) of a second [1] [2] or 1000 microseconds.
For 6/6 = 1.0 acuity, the size of a letter on the Snellen chart or Landolt C chart is a visual angle of 5 arc minutes (1 arc min = 1/60 of a degree), which is a 43 point font at 20 feet. [10] By the design of a typical optotype (like a Snellen E or a Landolt C), the critical gap that needs to be resolved is 1/5 this value, i.e., 1 arc min.
A milliradian (SI-symbol mrad, sometimes also abbreviated mil) is an SI derived unit for angular measurement which is defined as a thousandth of a radian (0.001 radian). ). Milliradians are used in adjustment of firearm sights by adjusting the angle of the sight compared to the barrel (up, down, left, or
In the year −2000 (2001 BCE) the May maximum was +12 minutes and a couple seconds while the November maximum was just less than 10 minutes. The secular change is evident when one compares a current graph of the equation of time (see below) with one from 2000 years ago, e.g., one constructed from the data of Ptolemy.
In the mid-1960s, to defeat the advantage of the recently introduced computers for the then popular rally racing in the Midwest, competition lag times in a few events were given in centids (1 ⁄ 100 day, 864 seconds, 14.4 minutes), millids (1 ⁄ 1,000 day, 86.4 seconds), and centims (1 ⁄ 100 minute, 0.6 seconds) the latter two looking and ...
The rule states that over the first period the quantity increases by 1/12. Then in the second period by 2/12, in the third by 3/12, in the fourth by 3/12, fifth by 2/12 and at the end of the sixth period reaches its maximum with an increase of 1/12.
The rule to calculate significant figures for multiplication and division are not the same as the rule for addition and subtraction. For multiplication and division, only the total number of significant figures in each of the factors in the calculation matters; the digit position of the last significant figure in each factor is irrelevant.