Search results
Results from the WOW.Com Content Network
Thermoelectric cooling uses the Peltier effect to create a heat flux at the junction of two different types of materials. A Peltier cooler, heater, or thermoelectric heat pump is a solid-state active heat pump which transfers heat from one side of the device to the other, with consumption of electrical energy, depending on the direction of the current.
Thermoelectric acclimatization depends on the possibility of a Peltier cell of absorbing heat on one side and rejecting heat on the other side. [1] Consequently, it is possible to use them for heating [2] on one side and cooling on the other [3] and as a temperature control system. [4] Figure 1. Energy balance of a Peltier cell based heat pump
The Peltier effect can be considered as the back-action counterpart to the Seebeck effect (analogous to the back-EMF in magnetic induction): if a simple thermoelectric circuit is closed, then the Seebeck effect will drive a current, which in turn (by the Peltier effect) will always transfer heat from the hot to the cold junction.
The Peltier effect is the presence of heating or cooling at an electrified junction of two different conductors (1834). [7] His great experimental discovery was the heating or cooling of the junctions in a heterogeneous circuit of metals according to the direction in which an electric current is made to pass round the circuit.
The efficiency of a thermoelectric device for electricity generation is given by , defined as =.. The maximum efficiency of a thermoelectric device is typically described in terms of its device figure of merit where the maximum device efficiency is approximately given by [7] = + ¯ + ¯ +, where is the fixed temperature at the hot junction, is the fixed temperature at the surface being cooled ...
A thermoelectric generator (TEG), also called a Seebeck generator, is a solid state device that converts heat (driven by temperature differences) directly into electrical energy through a phenomenon called the Seebeck effect [1] (a form of thermoelectric effect).
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
The symmetrical Peltier effect (Jean Charles Athanse Peltier, 1785–1845) uses an electric current to produce temperature differences. In the middle part of the twentieth century the thermo-electric generator was often used in place of galvanic batteries .