Ads
related to: metal shop with overhang top or side of concrete floor and tableuline.com has been visited by 100K+ users in the past month
olympiabuildings.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
A steel girder formed from a vertical center web of steel plate with steel angles forming the top and bottom flanges welded, bolted or riveted to the web. Some deep plate girders also may have vertical stiffeners (angles) attached to the web to resist crippling (horizontal failure) of the web. Plinth
The main structure is of slender precast concrete columns, set in a grid pattern. The columns are supported with stainless steel posts, with similar caps on the top. The house is topped with a wide steel-framed roof, which overhangs the walls by seven feet. The floors are concrete. The facades are divided into four bays by the columns.
The Concrete Reinforcing Steel Institute (CRSI) has developed standard symbols, graphics, and formats for shop drawings and cut sheets that generally are used by reinforcing steel fabricators. [5] Each fabricator, has particular style for shop drawings and cut sheets, depending on the drafts people and Computer-aided design systems.
These are a modern version of the old storefront crank-up awnings of the last century. The two, three or four tension arms (width dependent) and a top tube are supported by a torsion bar. With a Traditional 'Open Style' folding arm awning the torsion bar (also known as square bar) fits into wall or soffit or fascia or roof mounted brackets that ...
The plan layout consists of both living suites to be facing each other in a north-south orientation rather than a typical side-by-side layout seen in duplexes. This would allow both spaces to feel a sense of width close to a "typical house". [10] What is most unique about the house is the origami like metal overhangs identical on both facades.
The front facade of the shop has a central doorway, with a large timber-framed four-panel window to the right of the door. The western side of the shop also has a timber double-door entrance. A metal window hood is located above the sash window at the end of the western wing of the rear section of the shop. [1]
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel-reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving (see below). [1] [2]
The Metal Shop, also known as Aeronautical Lab B, was a historic building located at 1022 South Burrill Avenue on the campus of the University of Illinois at Urbana–Champaign. Built in 1895, the building served as a metal shop for the university's architecture and engineering students.
Ads
related to: metal shop with overhang top or side of concrete floor and tableuline.com has been visited by 100K+ users in the past month
olympiabuildings.com has been visited by 10K+ users in the past month