Search results
Results from the WOW.Com Content Network
RPL [1] (Routing Protocol for Low-Power and Lossy Networks) is a routing protocol for wireless networks with low power consumption and generally susceptible to packet loss. It is a proactive protocol based on distance vectors and operates on IEEE 802.15.4, [2] optimized for multi-hop and many-to-one communication, but also supports one-to-one ...
This is a list of the IP protocol numbers found in the field Protocol of the IPv4 header and the Next Header field of the IPv6 header. It is an identifier for the encapsulated protocol and determines the layout of the data that immediately follows the header. Both fields are eight bits wide.
6LoWPAN (acronym of "IPv6 over Low-Power Wireless Personal Area Networks") [1] was a working group of the Internet Engineering Task Force (IETF). [2] It was created with the intention of applying the Internet Protocol (IP) even to the smallest devices, [3] enabling low-power devices with limited processing capabilities to participate in the Internet of Things.
This article lists protocols, categorized by the nearest layer in the Open Systems Interconnection model.This list is not exclusive to only the OSI protocol family.Many of these protocols are originally based on the Internet Protocol Suite (TCP/IP) and other models and they often do not fit neatly into OSI layers.
A routing protocol specifies how routers communicate with each other to distribute information that enables them to select paths between nodes on a computer network. Routers perform the traffic directing functions on the Internet; data packets are forwarded through the networks of the internet from router to router until they reach their ...
The payload of an IPv6 packet is typically a datagram or segment of the higher-level transport layer protocol, but may be data for an internet layer (e.g., ICMPv6) or link layer (e.g., OSPF) instead. IPv6 packets are typically transmitted over the link layer (i.e., over Ethernet or Wi-Fi), which encapsulates each packet in a frame.
ICMPv6 provides a minimal level of message integrity verification by the inclusion of a 16-bit checksum in its header. The checksum is calculated starting with a pseudo-header of IPv6 header fields according to the IPv6 standard, [6] which consists of the source and destination addresses, the packet length and the next header field, the latter of which is set to the value 58.
IPsec was a mandatory part of all IPv6 protocol implementations, [2] and Internet Key Exchange (IKE) was recommended, but with RFC 6434 the inclusion of IPsec in IPv6 implementations was downgraded to a recommendation because it was considered impractical to require full IPsec implementation for all types of devices that may use IPv6.