Search results
Results from the WOW.Com Content Network
Outboard: attached outside the ship. [20] Port: the left side of the ship, when facing forward (opposite of "starboard"). [1] Starboard: the right side of the ship, when facing forward (opposite of "port"). [1] Stern: the rear of a ship (opposite of "bow"). [1] Topside: the top portion of the outer surface of a ship on each side above the ...
In place of the afterdeck, a ship may be built with a poop deck, that is a deck that forms the roof of a cabin built in the rear, or "aft", part of the superstructure of a ship; a poop deck is usually higher up than an afterdeck. A ship may have its superstructure or aftercastle located in the stern and thus not have an afterdeck. The stern and ...
Vertical transom and stern of a modern cargo ship. In some boats and ships, a transom is the aft transverse surface of the hull that forms the stern of a vessel. Historically, they are a development from the canoe stern (or "double-ender") wherein which both bow and stern are pointed. Transoms add both strength and width to the stern.
This is an accepted version of this page This is the latest accepted revision, reviewed on 18 January 2025. Back or aft-most part of a ship or boat For other uses, see Stern (disambiguation). Detailed schematic of an elliptical or "fantail" stern The flat transom stern of the cargo ship Sichem Princess Marie-Chantal The stern is the back or aft -most part of a ship or boat, technically defined ...
Graphical representation of the dimensions used to describe a ship. Length between perpendiculars (often abbreviated as p/p, p.p., pp, LPP, LBP or Length BPP) is the length of a ship along the summer load line from the forward surface of the stem, or main bow perpendicular member, to the after surface of the sternpost, or main stern perpendicular member.
A sternpost is the upright structural member or post at the aft end of a ship or a boat, [1] [2] to which are attached the transoms and the rearmost part of the stern. [3] The sternpost may either be completely vertical or may be tilted or "raked" slightly aft. [4] It rests on or "fays to" the ship's keel. [1]
This construction relies heavily on support by a complex array of stays and shrouds. Each stay in either the fore-and-aft or athwartships direction has a corresponding one in the opposite direction providing counter-tension. Fore-and-aft the system of tensioning start with the stays that are anchored in front of each mast.
Throat – On a quadrilateral sail, the throat is the upper forward corner of the sail, at the bottom end of a gaff or other spar. [18] Gaff-rigged sails, and certain similar rigs, employ two halyards to raise the sails: the throat halyard raises the forward, throat end of the gaff, while the peak halyard raises the aft, peak end. [19]