Search results
Results from the WOW.Com Content Network
Below is the full 8086/8088 instruction set of Intel (81 instructions total). [2] These instructions are also available in 32-bit mode, in which they operate on 32-bit registers (eax, ebx, etc.) and values instead of their 16-bit (ax, bx, etc.) counterparts.
The INT3 instruction is a one-byte-instruction defined for use by debuggers to temporarily replace an instruction in a running program in order to set a code breakpoint. The more general INT XXh instructions are encoded using two bytes. This makes them unsuitable for use in patching instructions (which can be one byte long); see SIGTRAP.
The 8086 [3] (also called iAPX 86) [4] is a 16-bit microprocessor chip designed by Intel between early 1976 [citation needed] and June 8, 1978, when it was released. [5] The Intel 8088, released July 1, 1979, [6] is a slightly modified chip with an external 8-bit data bus (allowing the use of cheaper and fewer supporting ICs), [note 1] and is notable as the processor used in the original IBM ...
EVEX.W is used to specify floating-point format (0=FP32, 1=FP64) The bottom opcode bit is used to select between packed and scalar operation (0: packed, 1:scalar) For a given operation, all the scalar/packed variants belong to the same AVX-512 subset. The instructions all support result masking by opmask registers.
The x86 instruction set has several times been extended with SIMD (Single instruction, multiple data) instruction set extensions.These extensions, starting from the MMX instruction set extension introduced with Pentium MMX in 1997, typically define sets of wide registers and instructions that subdivide these registers into fixed-size lanes and perform a computation for each lane in parallel.
x86 assembly language is a family of low-level programming languages that are used to produce object code for the x86 class of processors. These languages provide backward compatibility with CPUs dating back to the Intel 8008 microprocessor, introduced in April 1972.
Bit manipulation instructions sets (BMI sets) are extensions to the x86 instruction set architecture for microprocessors from Intel and AMD. The purpose of these instruction sets is to improve the speed of bit manipulation. All the instructions in these sets are non-SIMD and operate only on general-purpose registers.
Most, but not all, instructions that use DS by default will accept an ES override prefix. Processor stack references, either implicitly (e.g. push and pop instructions) or explicitly (memory accesses using the (E)SP or (E)BP registers) use the stack segment specified by the segment selector held in the SS register.