Search results
Results from the WOW.Com Content Network
English: OBD-II type B female connector shape and pinout (The pins inside the connector are female, while the connector itself —the plastic body— is male). Español: Aspecto y posición de los contactos en un conector OBD-II hembra (los contactos son hembra, pero el cuerpo del conector es macho).
For ALDL connections, pin 9 is the data stream, pins 4 and 5 are ground, and pin 16 is the battery voltage. An OBD 1.5 compatible scan tool is required to read codes generated by OBD 1.5. Additional vehicle-specific diagnostic and control circuits are also available on this connector.
Unfortunately, the definition of which signals were present on each pin varied between vehicle models. There were generally only three pins used for basic ALDL —ground, battery voltage, and a single line for data—, although other pins were often used for additional vehicle-specific diagnostic information and control interfaces.
The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections .
Sensor ground: Ground side of coolant, fuel, MAP, and TP sensors 26 green/white: Air bypass valve: 48-58Ω to pin 1 27 black/gray: Signal ground - 28 blue/gray: Air bypass valve: 48-58Ω to pin 29 29 orange: Air bypass valve: 48-58Ω to pin 28 30 pink: Fault display data: Output to main connector 31 black/green or black/yellow: Diagnostic plug ...
From 1996 to 2001, the 6-pin Deutsch-connector was standard. Beginning in 2001, most OEMs converted to the 9-pin Deutsch. Some OEMs still use the 6-pin Deutsch. It has mostly been used for US made vehicles, and also by Volvo. Other European brands have usually used KWP. The pinout for the 9-pin connector is:
To the ignition cassette there are four triggering lines connected from the Trionic ECU, pin 9 (cyl. 1), pin 10 (cyl. 2), pin 11 (cyl. 3) and pin 12 (cyl. 4). When the ECU is grounding pin 9, the primary coil for the first cylinder is grounded (via the ignition cassettes B+ intake) and 400 V is transformed up to a maximum of 40 kV in the ...