Search results
Results from the WOW.Com Content Network
The original field emitter array was the Spindt array, in which the individual field emitters are small sharp molybdenum cones. Each is deposited inside a cylindrical void in an oxide film, with a counterelectrode deposited on the top of the film. The counterelectrode (called the "gate") contains a separate circular aperture for each conical ...
An electron gun (also called electron emitter) is an electrical component in some vacuum tubes that produces a narrow, collimated electron beam that has a precise kinetic energy. The largest use is in cathode-ray tubes (CRTs), used in older television sets , computer displays and oscilloscopes , before the advent of flat-panel displays .
For a metal emitter, the β−value for a given position will be constant (independent of voltage) under the following conditions: (1) the apparatus is a "diode" arrangement, where the only electrodes present are the emitter and a set of "surroundings", all parts of which are at the same voltage; (2) no significant field-emitted vacuum space ...
The transistor continuously monitors V diff and adjusts its emitter voltage to equal V in minus the mostly constant V BE (approximately one diode forward voltage drop) by passing the collector current through the emitter resistor R E. As a result, the output voltage follows the input voltage variations from V BE up to V +; hence the name ...
Schottky-emitter electron source of an Electron microscope. A field emission gun (FEG) is a type of electron gun in which a sharply pointed Müller-type [clarification needed] emitter [1]: 87–128 is held at several kilovolts negative potential relative to a nearby electrode, so that there is sufficient potential gradient at the emitter surface to cause field electron emission.
The input signal is applied across the ground and the base circuit of the transistor. The output signal appears across ground and the collector of the transistor. Since the emitter is connected to the ground, it is common to signals, input and output. The common-emitter circuit is the most widely used of junction transistor amplifiers.
A high voltage-gradient field is created between the emitters and a metal mesh suspended above them, pulling electrons from the tips of the emitters. This is a highly non-linear process, and small changes in voltage will quickly cause the number of emitted electrons to saturate.
An electron gun or electron emitter, is an electrical component in some vacuum tubes that uses surface emission; Others