enow.com Web Search

  1. Ads

    related to: stainless steel pipe bracket

Search results

  1. Results from the WOW.Com Content Network
  2. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    [19]: 71 The rubber sleeves are typically secured with stainless steel worm drive clamping bands, which compress the rubber to make a tight seal around the pipes and fittings. These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life.

  3. Hose clamp - Wikipedia

    en.wikipedia.org/wiki/Hose_clamp

    Ear clamps consist of a band (usually stainless steel) into which one or more “ears” or closing elements have been formed. The clamp is placed over the end of the hose or tube to be connected and when each ear is closed at the base of the ear with a special pincer tool, it permanently deforms, pulling the band, and causing the band to ...

  4. Corrugated stainless steel tubing - Wikipedia

    en.wikipedia.org/wiki/Corrugated_stainless_steel...

    CSST is used as an alternative to the older standard “black iron” (steel) gas pipe. The inner stainless steel layer of typical residential CSST is .2 to .3 mm thick while the wall thickness of typical residential “black iron” gas pipe is 3 to 4 mm thick. CSST is more expensive than “black iron” gas pipe.

  5. Pipe support - Wikipedia

    en.wikipedia.org/wiki/Pipe_support

    A pipe support or pipe hanger is a designed element that transfer the load from a pipe to the supporting structures. The load includes the weight of the pipe proper, the content that the pipe carries, all the pipe fittings attached to pipe, and the pipe covering such as insulation. The four main functions of a pipe support are to anchor, guide ...

  6. Push-to-pull compression fittings - Wikipedia

    en.wikipedia.org/wiki/Push-to-pull_compression...

    There was a reusable fitting that could be unscrewed and a slimmer single-use fitting which could not. A new grab washer was required each time if a joint was reused. The fittings were designed for use with polybutylene pipe, while stainless steel pipe inserts were used for internal support. Hepworth was acquired by Wavin in 2005. [1]

  7. Strut channel - Wikipedia

    en.wikipedia.org/wiki/Strut_channel

    Strut is normally made of sheet steel, with a zinc coating (), paint, epoxy, powder coat, or other finish.. Strut channel is also manufactured from stainless steel for use where rusting might become a problem (e.g., outdoors, facilities with corrosive materials), from aluminium alloy when weight is an issue or from fiberglass for very corrosive environments.

  1. Ads

    related to: stainless steel pipe bracket