enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Visqueen - Wikipedia

   en.wikipedia.org/wiki/Visqueen

   It is the registered trade mark of British Polythene Limited in numerous countries throughout the world. It is commonly between 4 and 10 mils (0.004 to 0.01 in./0.1 to 0.25 mm) thick and is available in clear, opaque, blue, and black. [1] [citation needed] Visqueen is used for many purposes.

3. Plastic film - Wikipedia

   en.wikipedia.org/wiki/Plastic_film

   Film strip (photographic film) 6 mil polyethylene plastic sheet as vapor barrier in construction Confectionery packaging made of PLA-blend bio-flex bioplastic Shrink-wrapped OH-58 Kiowa helicopters to be shipped. Plastic film is a thin continuous polymeric material. Thicker plastic material is often called a "sheet".

4. Vapor barrier - Wikipedia

   en.wikipedia.org/wiki/Vapor_barrier

   Polyethylene plastic sheet, 4 or 6 thou (0.10 or 0.15 mm), 0.03 US perm (1.7 SI perm). Advanced Polyethylene vapor retarders that pass the ASTM E 1745 standard tests ≤0.3 US perm (17 SI perm). Asphalt-coated kraft paper, often attached to one side of fiberglass batts, 0.40 US perm (22 SI perm). Metallized film

5. Thousandth of an inch - Wikipedia

   en.wikipedia.org/wiki/Thousandth_of_an_inch

   The thou, or mil, is most commonly used in engineering and manufacturing in non-metric countries. For example, in specifying: The thickness of items such as paper, film, foil, wires, paint coatings, latex gloves, plastic sheeting, and fibers For example, most plastic ID cards are about 30 thou (0.76 mm) in thickness.

6. Polyethylene - Wikipedia

   en.wikipedia.org/wiki/Polyethylene

   Since 2008, Japan has increased plastic recycling, but still has a large amount of plastic wrapping which goes to waste. Plastic recycling in Japan is a potential US$90 billion market. [26] It is possible to rapidly convert polyethylene to hydrogen and graphene by heating. The energy needed is much less than for producing hydrogen by electrolysis.

7. Plastic extrusion - Wikipedia

   en.wikipedia.org/wiki/Plastic_extrusion

   A common post-extrusion process for plastic sheet stock is thermoforming, where the sheet is heated until soft (plastic), and formed via a mold into a new shape. When vacuum is used, this is often described as vacuum forming. Orientation (i.e. ability/ available density of the sheet to be drawn to the mold which can vary in depths from 1 to 36 ...