Search results
Results from the WOW.Com Content Network
Depending on the FBE coating system, full cure can be achieved in less than one minute to few minutes in case of long cure FBE's, which are used for internal pipe coating applications. Rebars are coated in a similar manner as coating application, on the exterior of pipes. For FBE coating application on the interior of pipe surface, a lance is used.
The first heat-shrinkable sleeves were introduced [when?] as polyethylene pipeline coatings started to replace bituminous or tape coatings in the oil and gas industry. At the time, the processing for polyethylene to make the sleeve backing was new technology and the adhesives used in sleeves were much the same as those used on pipeline coating.
A water-based pipe coating is an environmentally friendly coating that is applied to the inner and outer surfaces of ductile iron pipe. The coating serves to protect the water supply lines from corrosion whether from the outside or the inside. It also serves to protect the drinking water from contamination. The coating is an emulsion ...
Newly issued USDOT regulation Title 49 CFR 192.112, in the section for Additional design requirements for steel pipe using alternative maximum allowable operating pressure requires that "The pipe must be protected against external corrosion by a non-shielding coating" (see coatings section on standard). Also, the NACE SP0169:2007 standard ...
Section of DICL pipe (ductile iron concrete lined), commonly used for utility water mains, showing iron casing, concrete lining, and textured polymer protective coatings on the inner and outer surfaces. Ductile iron pipe is pipe made of ductile cast iron commonly used for potable water transmission and distribution. [1]
Thermal spraying can provide thick coatings (approx. thickness range is 20 microns to several mm, depending on the process and feedstock), over a large area at high deposition rate as compared to other coating processes such as electroplating, physical and chemical vapor deposition. Coating materials available for thermal spraying include ...
Electroless nickel-phosphorus coatings with less than 7% phosphorus are solid solutions with a microcrystalline structure, with each grain 2–6 nm across. Coatings with more than 10% phosphorus are amorphous. Between these two limits, the coating is a mixture of amorphous and microcrystalline materials. [16]
Phosphate conversion coating is a chemical treatment applied to steel parts that creates a thin adhering layer of iron, zinc, or manganese phosphates to improve corrosion resistance or lubrication or as a foundation for subsequent coatings or painting. [1] [2] [3] It is one of the most common types of conversion coating.