enow.com Web Search

  1. Ad

    related to: rocker arm noise

Search results

  1. Results from the WOW.Com Content Network
  2. Rocker arm - Wikipedia

    en.wikipedia.org/wiki/Rocker_arm

    A rocker arm is a valvetrain component that typically transfers the motion of a pushrod in an overhead valve internal combustion engine to the corresponding intake/exhaust valve. Rocker arms in automobiles are typically made from stamped steel, or aluminum in higher-revving applications.

  3. Desmodromic valve - Wikipedia

    en.wikipedia.org/wiki/Desmodromic_valve

    However, a desmodromic system must deal with the inertia of the two rocker arms per valve, so this advantage depends greatly on the skill of the designer. Another disadvantage is the contact point between the cams and rocker arms. It is relatively easy to use roller tappets in conventional valvetrains, although it does add considerable moving mass.

  4. Hydraulic tappet - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_tappet

    through a pushrod which actuates the valve via a rocker mechanism (in an overhead valve (OHV) engine); via direct contact with the valve stem or rocker arm (in an overhead camshaft (OHC) configuration). Oil under constant pressure is supplied to the lifter via an oil channel, through a small hole in the lifter body.

  5. Tappet - Wikipedia

    en.wikipedia.org/wiki/Tappet

    On most overhead valve (OHV) engines, proper clearance between the camshaft and tappet is achieved by turning a set screw in the end of the rocker arm that contacts the end of the pushrod until a desired gap is achieved using a feeler gauge. Too large a gap results in wear from misaligned parts and compromised engine performance, and too small ...

  6. Valvetrain - Wikipedia

    en.wikipedia.org/wiki/Valvetrain

    Depending on the design used, the valves are actuated by a rocker arm, finger, or bucket tappet. Overhead valve engines use rocker arms, which are actuated from below indirectly (through the pushrods) by the cam lobes. Overhead camshaft engines use fingers or bucket tappets, which are actuated from above directly by the cam lobes. [3]

  7. Compression release engine brake - Wikipedia

    en.wikipedia.org/wiki/Compression_release_engine...

    The typical compression brake consists of a hydraulic system using engine oil which transfers the motion of the fuel injector rocker arm to the engine's exhaust valve(s). When activated, the exhaust valve opens very briefly near the engine's top dead center , and releases the compressed air in the cylinder so that the air compression energy is ...

  8. Toyota NR engine - Wikipedia

    en.wikipedia.org/wiki/Toyota_NR_engine

    The application of intake valve type roller rocker arm, which reduces the friction produced when the camshaft is running. The application of Dual VVT-i system, which adjusts timing on both intake and exhaust camshafts. Improved cylinder head design. Longer intake valve, which improves lower-end torque. [12] Compatible with E20 fuel (Dual VVT-iE ...

  9. MIVEC - Wikipedia

    en.wikipedia.org/wiki/MIVEC

    The low-lift cams and rocker arms - which drive separate intake valves - are positioned on either side of a centrally located high-lift cam. Each of the intake valves is operated by a low-lift cam and rocker arm, while placing a T-lever between them allows the valves to follow the action of the high-lift cam. [8]

  1. Ad

    related to: rocker arm noise