Search results
Results from the WOW.Com Content Network
Bonded anchors are also referred as adhesive anchors [9] or chemical anchors. The anchoring material is an adhesive (also called mortar) [3] usually consisting of epoxy, polyester, or vinylester resins. [1] In bonded anchors, the force-transfer mechanism is based on bond stresses provided by binding organic materials.
In past decades attempts to protect concrete have included sealers ranging from wax to linseed oil. Today, high quality concrete sealers can block up to 99% of surface moisture. There are two main sealer categories: topical sealers (coatings) and penetrating sealers (reactive).
A deep-penetrating anchor (DPA) is conceptually similar to a torpedo anchor: it features a dart-shaped, thick-walled, steel cylinder with flukes attached to the upper section of the anchor. A full-scale DPA is approximately 15 metres (49 ft) in length, 1.2 metres (4 ft) in diameter, and weighs on the order of 50–100 tonnes (49–98 long tons ...
An anchor plate, floor plate [1] or wall washer is a large plate or washer connected to a tie rod or bolt. Anchor plates are used on exterior walls of masonry buildings, for structural reinforcement against lateral bowing. Anchor plates are made of cast iron, sometimes wrought iron or steel, and are often made in a decorative style. [2]
Alphabet's Google is facing a second complaint from a U.S. labor board claiming that it is the employer of contract workers and must bargain with their union, the agency said on Monday. The ...
WASHINGTON (Reuters) -A U.S. Justice Department watchdog report released on Thursday debunked claims by far-right conspiracy theorists who falsely alleged that FBI operatives were secretly ...
Her assailant strangled her nearly unconscious twice. Morgan Metzer: It's the worst feeling in the world to think you're dying. And you feel like you're going to be tortured beforehand.
Grouted tiebacks can be constructed as steel rods drilled through a concrete wall out into the soil or bedrock on the other side. Grout is then pumped under pressure into the tieback anchor holes to increase soil resistance and thereby prevent tiebacks from pulling out, reducing the risk for wall destabilization.