enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. x86 instruction listings - Wikipedia

    en.wikipedia.org/wiki/X86_instruction_listings

    Below is the full 8086/8088 instruction set of Intel (81 instructions total). [2] These instructions are also available in 32-bit mode, in which they operate on 32-bit registers (eax, ebx, etc.) and values instead of their 16-bit (ax, bx, etc.) counterparts.

  3. Minimal instruction set computer - Wikipedia

    en.wikipedia.org/wiki/Minimal_instruction_set...

    Separate from the stack definition of a MISC architecture, is the MISC architecture being defined by the number of instructions supported. Typically a minimal instruction set computer is viewed as having 32 or fewer instructions, [1] [2] [3] where NOP, RESET, and CPUID type instructions are usually not counted by consensus due to their fundamental nature.

  4. x86 Bit manipulation instruction set - Wikipedia

    en.wikipedia.org/wiki/X86_Bit_manipulation...

    Bit manipulation instructions sets (BMI sets) are extensions to the x86 instruction set architecture for microprocessors from Intel and AMD. The purpose of these instruction sets is to improve the speed of bit manipulation. All the instructions in these sets are non-SIMD and operate only on general-purpose registers.

  5. List of discontinued x86 instructions - Wikipedia

    en.wikipedia.org/wiki/List_of_discontinued_x86...

    These instructions were introduced in the Cyrix 6x86MX and MII processors, and were also present in the MediaGXm and Geode GX1 [53] processors. (In later non-Cyrix processors, all of their opcodes have been used for SSE or SSE2 instructions.) These instructions are integer SIMD instructions acting on 64-bit vectors in MMX registers or memory.

  6. Instruction list - Wikipedia

    en.wikipedia.org/wiki/Instruction_list

    Instruction list (IL) is one of the 5 languages supported by the initial versions of IEC 61131-3 standard, and subsequently deprecated in the third edition. [1] It is designed for programmable logic controllers (PLCs). It is a low level language and resembles assembly. All of the languages share IEC61131 Common Elements. The variables and ...

  7. Fuse cutout - Wikipedia

    en.wikipedia.org/wiki/Fuse_cutout

    In electrical distribution, a fuse cutout or cut-out fuse (often referred to as a cutout) is a combination of a fuse and a switch, used in primary overhead feeder lines and taps to protect distribution transformers from current surges and overloads. An overcurrent caused by a fault in the transformer or customer circuit will cause the fuse to ...

  8. D-subminiature - Wikipedia

    en.wikipedia.org/wiki/D-subminiature

    A D-sub contains two or more parallel rows of pins or sockets usually surrounded by a D-shaped metal shield, or shell, that provides mechanical support, ensures correct orientation, and may screen against electromagnetic interference.

  9. DIN 43700 - Wikipedia

    en.wikipedia.org/wiki/DIN_43700

    DIN 43700, was the specification by the Deutsches Institut für Normung for nominal front- and cut-out dimensions of measurement and control instruments for panel mounting. It has now been superseded by DIN IEC 61554:2002-08.