Search results
Results from the WOW.Com Content Network
Decanting a liquid from a solid. Decantation is a process for the separation of mixtures of immiscible liquids or of a liquid and a solid mixture such as a suspension. [1] The layer closer to the top of the container—the less dense of the two liquids, or the liquid from which the precipitate or sediment has settled out—is poured off, leaving denser liquid or the solid behind.
In the classic dilution refrigerator (known as a wet dilution refrigerator), the 3 He is precooled and purified by liquid nitrogen at 77 K and a 4 He bath at 4.2 K. Next, the 3 He enters a vacuum chamber where it is further cooled to a temperature of 1.2–1.5 K by the 1 K bath , a vacuum-pumped 4 He bath (as decreasing the pressure of the ...
A stirring rod is used for mixing liquids, or solids and liquids. Stir rods are used as part of proper laboratory technique when decanting supernatants because the contact helps to negate the adhesion between the side of the glassware and the supernatant that is responsible for the liquid running down the side. Using a stir rod also grants more ...
Common absorption refrigerators use a refrigerant with a very low boiling point (less than −18 °C (0 °F)) just like compressor refrigerators.Compression refrigerators typically use an HCFC or HFC, while absorption refrigerators typically use ammonia or water and need at least a second fluid able to absorb the coolant, the absorbent, respectively water (for ammonia) or brine (for water).
These are used to decant two immiscible fluids. It can be graduated, though this is not very common. Hirsch funnels are shaped much like normal funnels, but contain holes or sintered glass at the base for quick filtrations. Dropping funnels are a cylindrical, regularly graduated funnel with standard taper ground glass joints. These are often ...
All of these solvents form a clear delineation between the two liquids. [2] The more dense liquid, typically the aqueous phase unless the organic phase is halogenated, sinks to the bottom of the funnel and can be drained out through a valve away from the less dense liquid, which remains in the separatory funnel. [3]
For example, two liquids which cannot be mixed because of different densities (e.g. oil and water) are separated from a solids phase. The heavy liquid (water) collects in the middle between the oil and the solids layer. Thus the two liquids separated from each other can be drawn off from the decanter.
The liquid entering the circulation evaporator will boil in the separator, not on a heating surface, hence minimising fouling, whereas with plate evaporators, boiling will occur on a heating surface. [15] It is for this reason that circulation evaporators are preferred for liquids with a higher tendency to foul.