Search results
Results from the WOW.Com Content Network
Traditional lime mortar is a combination of lime putty and aggregate (usually sand). A typical modern lime mortar mix would be 1 part lime putty to 3 parts washed, well graded, sharp sand. Other materials have been used as aggregate instead of sand.
The resulting substance, known as quicklime or lump-lime, was subsequently pulverized into a fine powder and combined with water in a process called "slaking." Through this procedure, a fundamental binding agent called "lime putty" was created and utilized for plastering purposes. The slaked lime, a dense and moist substance, would then be ...
This contrasts with calcium hydroxide, also called slaked lime or air lime that is used to make lime mortar, the other common type of lime mortar, which sets by carbonation (re-absorbing carbon dioxide (CO 2) from the air). Hydraulic lime provides a faster initial set and higher compressive strength than air lime, and hydraulic lime will set in ...
In wet slaking, a slight excess of water is added to hydrate the quicklime to a form referred to as lime putty. Because lime has an adhesive property with bricks and stones, it is often used as a binding mortar in masonry works. It is also used in whitewashing as a wall-coat to allow the whitewash to adhere the wall.
Some plasterers used lime putty in second coat instead of dehydrated lime in the render. The mortar is applied to about 5 mm thick and when the render hardens is screeded off straight. A wood float or plastic float is used to rub down the walls.
In Economy Village, the rear and middle wythes of brick dwelling walls are laid in a clay and sand mortar with the front wythe bedded in a lime and sand mortar to provide a weather proof seal to protect from water penetration. This allowed a rendering of clay plaster and setting coat of thin lime and fine sand on exterior-walled rooms.
Mortar holding weathered bricks. Mortar is a workable paste which hardens to bind building blocks such as stones, bricks, and concrete masonry units, to fill and seal the irregular gaps between them, spread the weight of them evenly, and sometimes to add decorative colours or patterns to masonry walls.
Lime or gypsum plaster is then applied, typically using a wooden board as the application tool. The applier drags the board upward over the wall, forcing the plaster into the gaps between the lath and leaving a layer on the front the depth of the temporary guides, typically about 1 ⁄ 4 inch (6.4 mm).