enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Copper foil - Wikipedia

   en.wikipedia.org/wiki/Copper_foil

   Copper foil. Copper foil is a thin sheet of copper metal that is widely used in various applications due to its excellent electrical conductivity, malleability, and corrosion resistance. It is an essential material in the electronics industry, especially for manufacturing printed circuit boards (PCBs) and other electronic components. [1]

3. Perfboard - Wikipedia

   en.wikipedia.org/wiki/Perfboard

   Top of a copper clad Perfboard with solder pads for each hole. Perfboard is a material for prototyping electronic circuits.It is a thin, rigid sheet with holes pre-drilled at standard intervals across a grid, usually a square grid of 0.1 inches (2.54 mm) spacing.

4. FR-4 - Wikipedia

   en.wikipedia.org/wiki/FR-4

   FR-4 is a common material for printed circuit boards (PCBs). A thin layer of copper foil is typically laminated to one or both sides of an FR-4 glass epoxy panel. These are commonly referred to as copper clad laminates. The copper thickness or copper weight can vary and so is specified separately.

5. Printed circuit board - Wikipedia

   en.wikipedia.org/wiki/Printed_circuit_board

   A printed circuit board (PCB), also called printed wiring board (PWB), is a laminated sandwich structure of conductive and insulating layers, each with a pattern of traces, planes and other features (similar to wires on a flat surface) etched from one or more sheet layers of copper laminated onto or between sheet layers of a non-conductive ...

6. Stripboard - Wikipedia

   en.wikipedia.org/wiki/Stripboard

   Stripboard is the generic name for a widely used type of electronics prototyping material for circuit boards characterized by a pre-formed 0.1 inches (2.54 mm) regular (rectangular) grid of holes, with wide parallel strips of copper cladding running in one direction all the way along one side of an insulating bonded paper board.

7. Breadboard - Wikipedia

   en.wikipedia.org/wiki/Breadboard

   In the early days of radio, amateurs nailed bare copper wires or terminal strips to a wooden board (often literally a bread cutting board) and soldered electronic components to them. [1] Sometimes a paper schematic diagram was first glued to the board as a guide to placing terminals, then components and wires were installed over their symbols ...