enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Thousandth of an inch - Wikipedia

    en.wikipedia.org/wiki/Thousandth_of_an_inch

    A thousandth of an inch is a derived unit of length in a system of units using inches. Equal to 1 ⁄ 1000 of an inch, a thousandth is commonly called a thou / ˈ θ aʊ / (used for both singular and plural) or, particularly in North America, a mil (plural mils). The words are shortened forms of the English and Latin words for "thousand" (mille ...

  3. Drill bit sizes - Wikipedia

    en.wikipedia.org/wiki/Drill_bit_sizes

    For Morse taper-shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to 3¼ inches, and a single 1/4 inch increment to 3½ inches. One aspect of this method of sizing is that the size increment between drill bits ...

  4. Inch - Wikipedia

    en.wikipedia.org/wiki/Inch

    This is approximately ⁠ 1 / 8inch per mile; 12.7 kilometres is exactly 500,000 standard inches and exactly 499,999 survey inches. This difference is substantial when doing calculations in State Plane Coordinate Systems with coordinate values in the hundreds of thousands or millions of feet.

  5. Point (typography) - Wikipedia

    en.wikipedia.org/wiki/Point_(typography)

    The Fournier scale: two inches in total, divided into four half-inches, the medium intervals are one line (1 ⁄ 12 inch), and the smallest intervals are 1 ⁄ 36 inch; no intervals for the point is given, though. Fournier printed a reference scale of 144 points over two inches; however, it was too rough to accurately measure a single point. [11]

  6. List of drill and tap sizes - Wikipedia

    en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

    The major minus pitch technique also works for inch-based threads, but you must first calculate the pitch by converting the fraction of threads-per-inch (TPI) into a decimal. For example, a screw with a pitch of 1/20 in (20 threads per inch) has a pitch of 0.050 in and a 1 ⁄ 13 in pitch (13 threads per inch) has a pitch of 0.077 in.

  7. Twip - Wikipedia

    en.wikipedia.org/wiki/Twip

    Twips are screen-independent units to ensure that the proportion of screen elements are the same on all display systems. A twip is defined as being 1 ⁄ 1440 of an inch (approximately 17.64 μm). A pixel is a screen-dependent unit, standing for 'picture element'. A pixel is a dot that represents the smallest graphical measurement on a screen.

  8. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  9. Unified Thread Standard - Wikipedia

    en.wikipedia.org/wiki/Unified_Thread_Standard

    The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.