Search results
Results from the WOW.Com Content Network
Amplifier and loudspeaker with two elements and crossover networks. Top: normal connection. Bottom: bi-wiring. Loudspeaker bi-wired using banana plugs. Bi-wiring is a means of connecting a loudspeaker to an audio amplifier, primarily used in hi-fi systems. Normally, there is one pair of connectors on a loudspeaker and a single cable (two ...
In 1953, C-COR was the first to introduce cable powering which transmits power through coaxial cables for powering cable amplifiers. In 1965, it introduced the use of integrated circuits in amplifiers used on utility poles and in 1969 was the first to use heat fins on amplifiers.
A cellular repeater (also known as cell phone signal booster or cell phone signal amplifier) is a type of bi-directional amplifier used to improve cell phone reception. [citation needed] A cellular repeater system commonly consists of a donor antenna that receives and transmits signal from nearby cell towers, coaxial cables, a signal amplifier, and an indoor rebroadcast antenna.
In figure 21, an example is shown of a signal split up to feed multiple low power amplifiers, then recombined to feed a single antenna with high power. [52] Figure 21. Splitter and combiner networks used with amplifiers to produce a high power 40 dB (voltage gain 100) solid state amplifier Figure 22. Phase arrangement on a hybrid power combiner.
Longer cable runs are possible due to this increased noise immunity and 6 dB extra headroom. At higher frequencies, the output impedance of the output amplifier can change, resulting in a small imbalance. When driven in differential mode by two identical amplifiers, this impedance change will be the same for both lines, and thus cancelled out. [1]
Carries standard definition video and does not carry audio on the same cable. Mini-DIN 4-pin Component. In popular use, it refers to a type of analog video information that is transmitted or stored as three separate signals. Either RGB interfaces or YPbPr: 3 RCA jacks: Composite, S-Video, and Component: VIVO = Mini-DIN 9-pin with breakout cable.
A Tower Mounted Amplifier (TMA), or Mast Head Amplifier (MHA), is a low-noise amplifier (LNA) mounted as close as practical to the antenna in mobile masts or base transceiver stations. A TMA reduces the base transceiver station noise figure (NF) and therefore improves its overall sensitivity ; in other words the mobile mast is able to receive ...
In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...