enow.com Web Search

  1. Ads

    related to: parts of floppy drive cable and connectors function in computer

Search results

  1. Results from the WOW.Com Content Network
  2. Floppy disk drive interface - Wikipedia

    en.wikipedia.org/wiki/Floppy_disk_drive_interface

    A 'universal' cable would have four drive connectors, two for each size of FDD, although cables which have only two drive connectors are common. The cable is normally formed into a ribbon, and a twist located between the pairs of connectors for the drives (see image) is usually applied to the conductors for pins 10 to 16 inclusive. This allows ...

  3. Berg connector - Wikipedia

    en.wikipedia.org/wiki/Berg_connector

    Rear side of 3.5-inch floppy drive. Berg connector for power is shown on the left; data cable on right. Berg connector is a brand of electrical connector used in computer hardware. Berg connectors are manufactured by Berg Electronics Corporation of St. Louis, Missouri, now part of Amphenol.

  4. Floppy-disk controller - Wikipedia

    en.wikipedia.org/wiki/Floppy-disk_controller

    A floppy-disk controller (FDC) is a hardware component that directs and controls reading from and writing to a computer's floppy disk drive (FDD). It has evolved from a discrete set of components on one or more circuit boards to a special-purpose integrated circuit (IC or "chip") or a component thereof.

  5. Ribbon cable - Wikipedia

    en.wikipedia.org/wiki/Ribbon_cable

    Ribbon cable with three connectors. Ribbon cables are usually specified by two numbers: the spacing or pitch of the conductors, and the number of conductors or ways. A spacing of 0.05 inch (1.27 mm) is the most usual, allowing for a two-row connector with a pin spacing of 0.1 inch (2.54 mm).

  6. Parallel ATA - Wikipedia

    en.wikipedia.org/wiki/Parallel_ATA

    Starting with the 80-conductor cable defined for use in ATAPI5/UDMA4, the master Device 0 device goes at the far-from-the-host end of the 18-inch (460 mm) cable on the black connector, the slave Device 1 goes on the grey middle connector, and the blue connector goes to the host (e.g. motherboard IDE connector, or IDE card).

  7. Floppy disk - Wikipedia

    en.wikipedia.org/wiki/Floppy_disk

    8-inch floppy disk, inserted in drive, (3½-inch floppy diskette, in front, shown for scale) 3½-inch, high-density floppy diskettes with adhesive labels affixed The first commercial floppy disks, developed in the late 1960s, were 8 inches (203.2 mm) in diameter; [4] [5] they became commercially available in 1971 as a component of IBM products and both drives and disks were then sold ...

  8. Molex connector - Wikipedia

    en.wikipedia.org/wiki/Molex_connector

    The desktop computer hard-drive connector (AMP Mate-n-Lok 1-480424-0 power connector) is standard on all 5.25-inch floppy drives, 3.5-inch PATA and non-SCA SCSI disk drives; however, newer SATA disk drives employ a more advanced interconnection with 15 contacts. These advanced connection systems were first developed by Molex and other connector ...

  9. Disk controller - Wikipedia

    en.wikipedia.org/wiki/Disk_controller

    A disk controller is a controller circuit that enables a CPU to communicate with a hard disk, floppy disk or other kind of disk drive. It also provides an interface between the disk drive and the bus connecting it to the rest of the system. [1] [2] Early disk controllers were identified by their storage methods and data encoding.

  1. Ads

    related to: parts of floppy drive cable and connectors function in computer