Ads
related to: jeep axle identification guide by vinbumper.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
The Dana/Spicer Model 35 is an automotive axle. It has been manufactured by Dana Holding Corporation since 1985 when American Motors (AMC) sold its axle tooling equipment to Dana. [1] The axle was named AMC-15 when it was first made in 1962. [1] Dana upgraded the axle, and added IFS and Twin Traction Beam front axle variations. Dana 35 from a Jeep
The Dana/Spicer Model 60 is an automotive axle manufactured by Dana Holding Corporation and used in OEM pickup and limited passenger car applications by Chevrolet, Dodge, Chrysler, Jeep, Ford and Land Rover. There are front and rear versions of the Dana 60.
The Jeep CJ-10 was a CJ-bodied pickup truck based on a heavily modified Jeep J10 pickup truck. Produced from 1981 to 1985, it was sold and designed for export markets; Australia in particular. CJ-10A (1984–1986) The Jeep CJ-10A was a CJ-10-based flightline aircraft tug. Produced in Mexico from 1984 to 1986.
1993 Jeep Grand Cherokee; 1989–1999 Jeep Wrangler; 1992–1999 Dodge Dakota; Aisin BG6 — 6-speed transaxle 2007–2010 Chrysler Sebring (diesel engine) 2006–2011 Dodge Caliber (diesel engine) 2007–2010 Dodge Avenger (diesel engine) 2008–2010 Dodge Journey (diesel engine) 2006–2016 Jeep Compass (diesel engine) 2006–2017 Jeep ...
The Dana/Spicer Model 30 is an automotive axle manufactured by Dana Holding Corporation. It has been manufactured as a beam axle and independent suspension axle with several versions. 2011 Jeep Dana 30 differential Jeep Dana 30
AMC 20s have an 8 7/8" ring gear and use a 29 spline axle shaft. The AMC 20 was most often used with V8 engines in cars and Jeeps . It was also used in the AM General Humvee .
In the 1960s, Jeep used a unique Dana 44 IFS setup, that was short lived. In the 1980s and 1990s, Ford used a form of IFS known as "Twin Traction Beam" (TTB). This Dana 44 had no axle tubes but attached to the driver side traction beam, which also acted as a cover plate, and had "open air" axles which traveled through the beams to the spindles.
The clutch pack applies progressive 0 to 100% locking between the front and rear output shafts. For example, if the rear axle starts rotating at a significantly higher rate than the front axle, the gerotor pump causes the clutch pack to progressively lock, transferring torque to the front axle until both axles are driven at the same speed. The ...
Ads
related to: jeep axle identification guide by vinbumper.com has been visited by 100K+ users in the past month