Ads
related to: exterior grade lumber calculator square feet- 3616 E Broad St, Columbus, OH · Directions · (614) 358-1791
- Low-Maintenance Decking
Spend Less Time Working On Your
Deck & More Time Enjoying It.
- Find A Retailer Near You
When You're Ready, We're Ready.
Search Locations Near You.
- Cost Calculator
Turn Your Vision Into A View With
Our Unique Calculator Tool
- Get Inspired
View Galleries & Explore Ideas To
Bring Life To Your Space.
- Low-Maintenance Decking
metalroofnation.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada. It equals the volume of a board that is one foot (30.5 cm) in length, one foot (30.5 cm) in width, and one inch (2.54 cm) in thickness, or exactly 2.359 737 216 liters .
The most common dimension is 1.2 by 2.4 metres (3 ft 11 in × 7 ft 10 in) or the slightly larger imperial dimension of 4 feet × 8 feet. Plies vary in thickness from 1.4 mm to 4.3 mm. The number of plies—which is always odd—depends on the thickness and grade of the sheet. Roofing can use the thinner 16-millimetre (5 ⁄ 8 in) plywood.
Finger-jointed lumber – solid dimensional lumber lengths typically are limited to lengths of 22 to 24 feet (6.7–7.3 m), but can be made longer by the technique of "finger-jointing" by using small solid pieces, usually 18 to 24 inches (460–610 mm) long, and joining them together using finger joints and glue to produce lengths that can be ...
Interior loadbearing walls are framed in the same way as exterior walls. Studs are usually 1 + 1 ⁄ 2 in × 3 + 1 ⁄ 2 in (38 mm × 89 mm) lumber spaced at 16 in (410 mm) on center. This spacing may be changed to 12 or 24 in (300 or 610 mm) depending on the loads supported and the type and thickness of the wall finish used.
A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...
Layout marks left over from marking out identify the place where to cut joints and bore peg holes; carpenters also marked the location on a timber where they had levelled it, as part of the building process, and called these "level lines"; sometimes they made a mark two feet from a critical location, which was then called the "two-foot mark ...
Ads
related to: exterior grade lumber calculator square feet- 3616 E Broad St, Columbus, OH · Directions · (614) 358-1791
metalroofnation.com has been visited by 100K+ users in the past month