Search results
Results from the WOW.Com Content Network
It is also known as short-circuit test (because it is the mechanical analogy of a transformer short-circuit test), [1] locked rotor test or stalled torque test. [2] From this test, short-circuit current at normal voltage, power factor on short circuit, total leakage reactance, and starting torque of the motor can be found.
In mechanical engineering, backlash, sometimes called lash, play, or slop, is a clearance or lost motion in a mechanism caused by gaps between the parts. It can be defined as "the maximum distance or angle through which any part of a mechanical system may be moved in one direction without applying appreciable force or motion to the next part in mechanical sequence."
A flat spring fixed only at one end like a cantilever, while the free-hanging end takes the load. Coil spring Also known as a helical spring. A spring (made by winding a wire around a cylinder) is of two types: Tension or extension springs are designed to become longer under load. Their turns (loops) are normally touching in the unloaded ...
The common valve spring system is satisfactory for traditional mass-produced engines that do not rev highly and are of a design that requires low maintenance. [1] At the period of initial desmodromic development, valve springs were a major limitation on engine performance because they would break from metal fatigue.
The motor constant is winding independent (as long as the same conductive material is used for wires); e.g., winding a motor with 6 turns with 2 parallel wires instead of 12 turns single wire will double the velocity constant, , but remains unchanged.
A growler is an electrical device primarily used for testing a motor for shorted coils. A growler consists of a coil of wire wrapped around an iron core and connected to a source of alternating current. When placed on the armature or stator core of a motor the growler acts as the primary of a transformer and the armature coils act as the ...
Most systems employ eddy current, oil hydraulic, or DC motor produced loads because of their linear and quick load change abilities. The power is calculated as the product of angular velocity and torque. A motoring dynamometer acts as a motor that drives the equipment under test. It must be able to drive the equipment at any speed and develop ...
Air pressure acts on a piston or bellows diaphragm creating linear force on a valve stem. Alternatively, a quarter-turn vane-type actuator produces torque to provide rotary motion to operate a quarter-turn valve. A pneumatic actuator may be arranged to be spring-closed or spring-opened, with air pressure overcoming the spring to provide movement.