Search results
Results from the WOW.Com Content Network
Automobile tire damaged after an impact. A blowout (also known as a burst) is a rapid, explosive loss of inflation pressure of a pneumatic tire.. The primary cause for a blowout is encountering an object that cuts or tears the structural components of the tire to the point where the structure is incapable of containing the compressed air, with the escaping air adding to further tear through ...
Prior to 1964, tires were all made to a 90% aspect ratio. Tire size was specified as the tire width in inches and the diameter in inches – for example, 6.50-15. [24] From 1965 to the early 1970s, tires were made to an 80% aspect ratio. Tire size was again specified by width in inches and diameter in inches.
Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation , lateral force variation , conicity, ply steer, radial run-out , lateral run-out , and ...
Vehicles typically carry a spare tire, already mounted on a wheel rim, to be used in the event of a flat tire or blowout. Spare tires (sometimes called "doughnuts") for modern cars are smaller than regular tires (to save trunk space, weight and cost) and should not be used to drive very far before replacement with a full-size tire. A few ...
These represent the tire's resistance to the generation of heat at speed. Tires graded A effectively dissipate heat up to a maximum speed that is greater than 115 mph. B rates at a maximum between 100 mph and 115 mph. C rates at a maximum of between 85 mph to 100 mph. Tires that cannot grade up to C or higher cannot be sold in the US. [9]
ETRTO sizes apply to rims and tyres for vehicles of all types, including bicycles. The great advantage of ETRTO sizing is that it is unambiguous; previously, nominal dimensions were used which were interpreted in different ways by different countries and manufacturers - a problem for the end user.
Colorized tire footprint pressure distribution. The contact patch is the portion of a vehicle's tire that is in actual contact with the road surface.It is commonly used in the discussion of pneumatic (i.e. pressurized) tires, where the term is used strictly to describe the portion of the tire’s tread that touches the road surface.
Cold inflation pressure is the inflation pressure of tires as measured before a car is driven and the tires warmed up. Recommended cold inflation pressure is displayed in the owner's manual and on the Tire Information Placard attached to the vehicle door edge , pillar , glovebox door or fuel filler flap .