Search results
Results from the WOW.Com Content Network
Values are given in terms of temperature necessary to reach the specified pressure. Valid results within the quoted ranges from most equations are included in the table for comparison. A conversion factor is included into the original first coefficients of the equations to provide the pressure in pascals (CR2: 5.006, SMI: -0.875).
The boiling point of water is the temperature at which the saturated vapor pressure equals the ambient pressure. Water supercooled below its normal freezing point has a higher vapor pressure than that of ice at the same temperature and is, thus, unstable. Calculations of the (saturation) vapor pressure of water are commonly used in meteorology.
Table data obtained from CRC Handbook of Chemistry and Physics 47th ed. Note that "(s)" annotation indicates equilibrium temperature of vapor over solid. Otherwise the temperature is equilibrium of vapor over liquid. log 10 of Carbon tetrachloride vapor pressure.
The values were not computed according formulas widely used in the US, but using somewhat more exact formulas (see below), which can also be used to compute further values in the appropriate temperature ranges. The saturated vapor pressure over water in the temperature range of −100 °C to −50 °C is only extrapolated [Translator's note ...
It is a non-flammable, dense, colourless liquid with a "sweet" chloroform-like odour that can be detected at low levels. It was formerly widely used in fire extinguishers , as a precursor to refrigerants , an anthelmintic and a cleaning agent , but has since been phased out because of environmental and safety concerns.
According to the American Meteorological Society Glossary of Meteorology, saturation vapor pressure properly refers to the equilibrium vapor pressure of water above a flat surface of liquid water or solid ice, and is a function only of temperature and whether the condensed phase is liquid or solid. [17]
A saturation dome uses the projection of a P–v–T diagram (pressure, specific volume, and temperature) onto the P–v plane. The points that create the left-hand side of the dome represent the saturated liquid states, while the points on the right-hand side represent the saturated vapor states (commonly referred to as the “dry” region).
National Physical Laboratory, Kaye and Laby Tables of Physical and Chemical Constants; D. Ambrose, M.B. Ewing, M.L. McGlashan, Critical constants and second virial coefficients of gases (retrieved Dec 2005)