Search results
Results from the WOW.Com Content Network
In aerodynamics, the lift-to-drag ratio (or L/D ratio) is the lift generated by an aerodynamic body such as an aerofoil or aircraft, divided by the aerodynamic drag caused by moving through air. It describes the aerodynamic efficiency under given flight conditions. The L/D ratio for any given body will vary according to these flight conditions.
His 1961 car attempted to use the shaped underside method but there were too many other aerodynamic problems with the car for it to work properly. His 1966 cars used a dramatic high wing for their downforce. His Chaparral 2J "sucker car" of 1970 was revolutionary.
A wing of infinite span and uniform airfoil segment (or a 2D wing) would experience no induced drag. [11] The drag characteristics of a wing with infinite span can be simulated using an airfoil segment the width of a wind tunnel. [12] An increase in wingspan or a solution with a similar effect is one way to reduce induced drag.
Automotive aerodynamics differs from aircraft aerodynamics in several ways: The characteristic shape of a road vehicle is much less streamlined compared to an aircraft. The vehicle operates very close to the ground, rather than in free air. The operating speeds are lower (and aerodynamic drag varies as the square of speed).
The lower/nearer the wing is to the ground, the more pronounced the ground effect becomes. While in the ground effect, the wing requires a lower angle of attack to produce the same amount of lift. In wind tunnel tests, in which the angle of attack and airspeed remain constant, an increase in the lift coefficient ensues, [ 9 ] which accounts for ...
Aerodynamic aids can then be used to provide the necessary balance and stability characteristics at higher speeds. [3] Spoilers and wings on a vehicle have little effect at low speeds as improper designs may create undesirable responses and lower stability or efficiency for the car at high speeds. [3]
Based on the experience gained with the P87, the new car for 1988 was built with the help of the French coachbuilder Heuliez, called WM P88, refining and lightening the previous car (the weight saving was 65 kg ), equipping it with new rear suspensions that allowed the use of larger Venturi tunnels and creating an engine with a larger ...
The term drag area derives from aerodynamics, where it is the product of some reference area (such as cross-sectional area, total surface area, or similar) and the drag coefficient. In 2003, Car and Driver magazine adopted this metric as a more intuitive way to compare the aerodynamic efficiency of various automobiles.