Search results
Results from the WOW.Com Content Network
Device with grooves and chucks. A jig's primary purpose is to provide repeatability, accuracy, and interchangeability in the manufacturing of products. [1]An example of a jig is when a key is duplicated; the original is used as a jig so the new key can have the same path as the old one.
A bandsaw (also written band saw) is a power saw with a long, sharp blade consisting of a continuous band of toothed metal stretched between two or more wheels to cut material. They are used principally in woodworking , metalworking , and lumbering , but may cut a variety of materials.
The most common fence on a table saw is a rip fence, and is provided as standard with any new table saw. The rip fence is parallel to the saw blade and can be adjusted to different distances from the blade to set the size of the final cut. The fence remains static, while the workpiece is guided along the fence. [5]
A band saw [20] is used to make both irregularly shaped cuts and cuts through material thicker than a table saw can manage. It is much more robust [ 23 ] than the jigsaw or more delicate scroll saw , also regularly used in woodworking.
A hand-held circular saw is the most conventional circular saw. This miter saw is a circular saw mounted to swing to crosscut wood at an angle. A table saw. Tractor-driven circular saw
A resaw is a large band saw optimized for cutting timber along the grain to reduce larger sections into smaller sections or veneers. Resawing veneers requires a wide blade – commonly 2 to 3 inches (52–78 mm) – with a small kerf to minimize waste. Resaw blades of up to 1 inch (26 mm) may be fitted to a standard band saw.
A motorized miter saw. A miter saw or mitre saw is a saw used to make accurate crosscuts and miters in a workpiece by positioning a mounted blade onto a board. A miter saw in its earliest form was composed of a back saw in a miter box, but in modern implementation consists of a powered circular saw that can be positioned at a variety of angles and lowered onto a board positioned against a ...
"The blade, which must be of steel, is approximately rectangular in section.The maximum length of the blade is 88 cm (35 in). The minimum width of the blade, which must be at the button, is 4 mm (0.16 in); its thickness, also immediately below the button, must be at least 1.2 mm (0.047 in)."