Search results
Results from the WOW.Com Content Network
TaylorMade Golf Company is an American sports equipment manufacturing company based in Carlsbad, California, United States. The company focuses on the golf equipment market, producing golf clubs, balls, and clothing. TaylorMade Golf is currently a subsidiary of Centroid Investment Partners after it was purchased from KPS Capital Partners in May ...
A Tour Preferred version of the R7 Quad, 425, 460, and Superquad, supplied with a number of additional differently weighted cartridges for even more placement variations, non OEM shafts using models directly from the top shaft manufacturers such as Matrix, Fujikura, and Mitsubishi Rayon, instead of the 'co-engineered' models, and 1-degree open ...
Independent rotation of the input and output shafts is made possible by one shaft being located inside the hollow bore of the other shaft, with a bearing located between the two shafts. In a transmission for transverse engined vehicles (e.g., front-wheel-drive cars), there are usually only two shafts: input and countershaft (sometimes called ...
Shaft alignment is the process of aligning two or more shafts with each other to within a tolerated margin. The resulting fault if alignment is not achieved within the demanded specifications is shaft misalignment, which may be offset or angular. Faults can lead to premature wear and damage to systems.
The operating principle of a balance shaft system is that two shafts carrying identical eccentric weights rotate in opposite directions at twice the engine speed. The phasing of the shafts is such that the centrifugal forces produced by the weights cancel the vertical second-order forces (at twice the engine RPM) produced by the engine. [3]
A drive shaft, driveshaft, driving shaft, tailshaft (Australian English), propeller shaft (prop shaft), or Cardan shaft (after Girolamo Cardano) is a component for transmitting mechanical power, torque, and rotation, usually used to connect other components of a drivetrain that cannot be connected directly because of distance or the need to ...
A line shaft is a power-driven rotating shaft for power transmission that was used extensively from the Industrial Revolution until the early 20th century. Prior to the widespread use of electric motors small enough to be connected directly to each piece of machinery, line shafting was used to distribute power from a large central power source ...
A spline is a ridge or tooth [1] [2] [3] on a drive shaft that matches with a groove in a mating piece and transfers torque to it, maintaining the angular correspondence between them. For instance, a gear mounted on a shaft might use a male spline on the shaft that matches the female spline on the gear.