Search results
Results from the WOW.Com Content Network
Based on Stokes' law, the size of the oil droplet and density of the droplet will affect the rate of rise to the surface. The larger and lighter the droplet, the faster it will rise to the surface. By attaching a small gas bubble to an oil droplet, the density of the droplet decreases, which increases the rate at which it will rise to the surface.
Petroleum refinery in Anacortes, Washington, United States. Petroleum refining processes are the chemical engineering processes and other facilities used in petroleum refineries (also referred to as oil refineries) to transform crude oil into useful products such as liquefied petroleum gas (LPG), gasoline or petrol, kerosene, jet fuel, diesel oil and fuel oils.
A blowdown stack is an elevated vent or vertical stack that is used to vent the pressure of components of a chemical, refinery or other plant if there is a process problem or emergency. A blowdown stack can be used to complement a flare stack or as an alternative. The purpose is to prevent 'loss of containment' of volatile liquids and gases.
This may be by heat exchange with the incoming live crude and by cooling water in a heat exchanger. The dead, stabilized crude flows to tanks for storage or to a pipeline for transport to customers such as an oil refinery. [3] [4] [7] The stabilization tower may typically operate at approximately 50 to 200 psig (345 – 1378 kPa). [5]
Three-phase separators separate the well fluids into its three constituent phases: oil, gas and produced water. Oil may be transferred by road or rail tanker or by pipeline to an oil refinery. Gas may be used on the site to run gas engines to produce electricity or can be piped to local users. [3] Excess gas is burned in a ground flare.
Water need not be separated, and a single liquid (oil and water) phase produced together with a separate gas phase. Chemicals are added so that the crude and water emulsify. This process is then reversed at the storage and processing facility by adding demulsifiers that make the water separate out, and is drawn from the bottom of the tank.
A schematic diagram of a Visbreaker unit. The term coil (or furnace) visbreaking is applied to units where the cracking process occurs in the furnace tubes (or "coils")."). Material exiting the furnace is quenched to halt the cracking reactions: frequently this is achieved by heat exchange with the virgin material being fed to the furnace, which in turn is a good energy efficiency step, but ...
Brine treatment is commonly encountered when treating cooling tower blowdown, produced water from steam-assisted gravity drainage (SAGD), produced water from natural gas extraction such as coal seam gas, frac flowback water, acid mine or acid rock drainage, reverse osmosis reject, chlor-alkali wastewater, pulp and paper mill effluent, and waste ...