Search results
Results from the WOW.Com Content Network
Density system unit unit-code symbol or abbrev. notes sample default conversion combination output units Metric: kilogram per cubic metre: kg/m3 kg/m 3: 1.0 kg/m 3 (1.7 lb/cu yd)
Coal-water slurry fuel, Grade III. A coal-water slurry fuel is defined by a number of factors including its viscosity, particle size, rate of sedimentation, ignition temperature (800–850 °C [1,470–1,560 °F]), combustion temperature (950–1,150 °C [1,740–2,100 °F]), ash content and calorific value (3,700–4,700 kilocalories per kilogram [15.5–19.7 MJ/kg]).
More than 7 billion tons of coal are mined per year (2010), using approximately 200 litres of water per ton. [3] However, the amount of water required hinges on the surface characteristics of the coal being used. Most coal slurries require the addition of a surfactant to reduce the viscosity, ergo reduce the stress on pipelines and pumps. [4]
The kilogram per cubic metre (symbol: kg·m −3, or kg/m 3) is the unit of density in the International System of Units (SI). It is defined by dividing the SI unit of mass, the kilogram, by the SI unit of volume, the cubic metre. [1]
Its bank density (the density of a coal seam prior to breaking up during mining) is about 1346 kg/m 3 (84 lb/ft 3) while the bulk density of extracted coal is up to 833 kg/m 3 (52 lb/ft 3). [12] Bituminous coal characteristically burns with a smoky flame and softens and swells during combustion. [13]
In light-water reactors, 1 kg of natural uranium – following a corresponding enrichment and used for power generation– is equivalent to the energy content of nearly 10,000 kg of mineral oil or 14,000 kg of coal. [16] Comparatively, coal, gas, and petroleum are the current primary energy sources in the U.S. [17] but have a much lower energy ...
Knowledge of the density of each coal play is necessary to determine the properties of composites and blends. The density of the coal seam is necessary for conversion of resources into reserves. Relative density is normally determined by the loss of a sample's weight in water.
— "Values ranging from 21.3 to 21.5 gm/cm 3 at 20 °C have been reported for the density of annealed platinum; the best value being about 21.45 gm/cm 3 at 20 °C." 21.46 g/cm 3 — Rose, T. Kirke. The Precious Metals, Comprising Gold, Silver and Platinum .