Search results
Results from the WOW.Com Content Network
In network topology, a cable modem is a network bridge that conforms to IEEE 802.1D for Ethernet networking (with some modifications). The cable modem bridges Ethernet frames between a customer LAN and the coax network. Technically, it is a modem because it must modulate data to transmit it over the cable network, and it must demodulate data ...
The red curve is an epicycloid traced as the small circle (radius r = 1) rolls around the outside of the large circle (radius R = 3).. In geometry, an epicycloid (also called hypercycloid) [1] is a plane curve produced by tracing the path of a chosen point on the circumference of a circle—called an epicycle—which rolls without slipping around a fixed circle.
Cable operators can continue to rely on the existing provisioning and billing systems, cable modem termination system (CMTS) platforms, headend equipment, set-top boxes, conditional access technology and cable modems while gaining benefits inherent with RFoG and FTTx. RFoG provides several benefits over traditional network architecture:
Reception: At the consumer end, BPL modems receive the signals from the power lines. These modems are typically connected to routers or networking devices, allowing the distribution of the internet connection to multiple devices within the premises. The BPL modems serve as the interface between the power lines and the local area network (LAN).
Wi-Fi over Coax is a technology for extending and distributing Wi-Fi signals via coaxial cables.As an in-building wireless solution, Wi-Fi over Coax can make use of existing or new cabling with native impedance of 50 Ω shared by a Wi-Fi access point, cabling run, and antenna.
At the destination end of the cable or fiber, or the radio receiver, for each channel a local oscillator produces a signal at the carrier frequency of that channel, that is mixed with the incoming modulated signal. The frequencies subtract, producing the baseband signal for that channel again.
The F connector was invented by Eric E. Winston in the early 1950s while working for Jerrold Electronics on their development of cable television. [1] In the 1970s, it became commonplace on VHF, and later UHF, television antenna connections in the United States, as coaxial cables replaced twin-lead. It is now specified in IEC 61169-24:2019. [2]
Balanced pair cable has higher attenuation at higher frequencies. Therefore, the longer the wire between DSLAM and subscriber, the slower the maximum possible data rate due to the lower frequencies being used to limit the total attenuation (or due to the higher number of errors at higher frequencies, effectively lowering the overall frequency ...