Search results
Results from the WOW.Com Content Network
Another drawback of SVMs is that their performance is highly sensitive to the initial parameters, particularly to the kernel methods, [19] so in each signal dataset, a parameter tuning process is required to be conducted first. Therefore, the low speed of the training phase is a limitation of SVMs when it comes to its usage in fault detection ...
Failure mode and effects analysis (FMEA; often written with "failure modes" in plural) is the process of reviewing as many components, assemblies, and subsystems as possible to identify potential failure modes in a system and their causes and effects. For each component, the failure modes and their resulting effects on the rest of the system ...
A fault tree diagram. Fault tree analysis (FTA) is a type of failure analysis in which an undesired state of a system is examined. This analysis method is mainly used in safety engineering and reliability engineering to understand how systems can fail, to identify the best ways to reduce risk and to determine (or get a feeling for) event rates of a safety accident or a particular system level ...
The FRACAS process is a closed loop with the following steps: Failure Reporting (FR). The failures and the faults related to a system, a piece of equipment, a piece of software or a process are formally reported through a standard form (Defect Report, Failure Report). Analysis (A). Perform analysis in order to identify the root cause of failure.
The first piece of information added in an FMEDA is the quantitative failure data (failure rates and the distribution of failure modes) for all components being analyzed. The second piece of information added to an FMEDA is the probability of the system or subsystem to detect internal failures via automatic on-line diagnostics.
An open-circuit fault occurs if a circuit is interrupted by a failure of a current-carrying wire (phase or neutral) or a blown fuse or circuit breaker. In three-phase systems, a fault may involve one or more phases and ground, or may occur only between phases. In a "ground fault" or "earth fault", current flows into the earth.
The emphasis of the PDPC is to identify the consequential impact of failure on activity plans, and create appropriate contingency plans to limit risks. Process diagrams and planning tree diagrams are extended by a couple of levels when the PDPC is applied to the bottom level tasks on those diagrams.
Failure analysis is the process of collecting and analyzing data to determine the cause of a failure, often with the goal of determining corrective actions or liability. According to Bloch and Geitner, ”machinery failures reveal a reaction chain of cause and effect… usually a deficiency commonly referred to as the symptom…”. [ 1 ]