Search results
Results from the WOW.Com Content Network
In this case, the centrifugal switch consists of weights mounted to the shaft of the motor and held near the shaft by spring force. At rest, levers attached to the weights press a low-friction , non-conductive plate against a set of electrical contacts mounted to the motor housing, closing the contacts and connecting the starting winding to the ...
The company began as a division of the Coleman Company in 1958 and was acquired by Evcon in 1990, which in turn was acquired by Johnson Controls in 1996. [70] [71] [72] Of the twelve largest American furnace brand names represented at Gas Furnace Guide, the Coleman brand received an average ranking of 3.7 out of 5 stars. [73]
If the switch is always open, the start capacitor is not part of the circuit, so the motor does not start. If the switch is always closed, the start capacitor is always in the circuit, so the motor windings will likely burn out. If a motor does not start, the capacitor is far more likely the problem than the switch. [citation needed]
Current models use Coleman fuel or propane and use one or two gas mantles to produce an intense white light. In the past, the company also produced a range of cooking stoves and domestic irons. Today, Coleman manufactures camp stoves (Coleman produced the original " G.I. Pocket Stove "), sleeping bags , coolers , hot tubs , generators , watches ...
The G.I. pocket stove is 8 + 1 ⁄ 2 inches (220 mm) high and 4 + 1 ⁄ 2 inches (110 mm) in diameter, and weighs about 3 pounds (1.4 kg). It was designed to burn either leaded or unleaded automobile gasoline (sometimes referred to as "white gasoline" or pure gasoline, without lead or additives).
The usual compression, cooling and expansion seen in any refrigeration cycle is accomplished in the ACM by a centrifugal compressor, two air-to-air heat exchangers and an expansion turbine. Bleed air from the engines, an auxiliary power unit, or a ground source, which can be in excess of 150 °C and at a pressure of perhaps 32 psi (220 kPa ...
A sail switch, vane switch or flow switch is a mechanical switch that is actuated on or off in response to the flow or non-flow of a fluid such as air or water. [1] A sail switch typically operates through the use of a paddle or a diaphragm which gets displaced due to the force of fluid or air moving past it.
A vacuum hose connected to the intake manifold downstream of the throttle provides a reference pressure for the blowoff valve.. When the throttle is open, the air pressure on both sides of the blowoff valve's piston is equal, therefore the spring holds the valve closed.