Search results
Results from the WOW.Com Content Network
As the cases on many computers are not perfect shields, some of this radio-frequency energy can leak out and cause interference to radio (and sometimes TV) reception. Switched-mode power supplies or packs can be a source of interference. [quantify] These are used in consumer electronic products such as phone charges and in some lighting systems.
Noise, static or snow screen captured from a blank VHS tape. Noise, commonly known as static, white noise, static noise, or snow, in analog video, CRTs and television, is a random dot pixel pattern of static displayed when no transmission signal is obtained by the antenna receiver of television sets and other display devices.
The following is a listing of affiliates for Antenna TV, [1] a classic television network, which was launched on January 1, 2011, by Tribune Broadcasting [2] and is now owned by Nexstar Media Group. [ 3 ]
Outdoor antennas provide up to a 15 dB gain in signal strength and 15-20 dB greater rejection of ghost signals in analog TV. [6] Combined with a signal increase of 14 dB due to height and 11 dB due to lack of attenuating building walls, an outdoor antenna can result in a signal strength increase of up to 40 dB at the TV receiver. [6]
Once the screen has been scanned, the beam returns to the beginning of the first line. Close up image of analog color screen. A cathode-ray tube (CRT) television displays an image by scanning a beam of electrons across the screen in a pattern of horizontal lines known as a raster. At the end of each line, the beam returns to the start of the ...
One of the most common problems was the return to VHF frequencies by stations that had used them when they were analog. Over 480 stations were broadcasting digitally on the VHF spectrum after the transition, up from only 216 on the frequencies before. Many antennas marketed for digital TV are designed for UHF, which most digital stations use ...
Nominal analog blanking should not be confused with overscan, as overscan areas are part of the actual 4:3 or 16:9 image. For SMPTE 259M-C compliance, an SDTV broadcast image is scaled to 720 pixels wide for every 480 NTSC (or 576 PAL) lines of the image with the amount of non-proportional line scaling dependent on either the display or pixel ...
The system consists of a master antenna and a matching transformer to match the balanced antenna with unbalanced cable and amplifiers. [5] Most antennas have an impedance of around 300 Ω. To convert it to 75 Ω, a matching transformer (or balun) is used. For trunk line isolation, a resistive inductive device known as a splitter is used.