enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Template:Convert/list of units - Wikipedia

   en.wikipedia.org/wiki/Template:Convert/list_of_units

   The table below lists units supported by {{convert}}. More complete lists are linked for each dimension. For a complete list of all dimensions, see full list of units. {{Convert}} uses unit-codes, which are similar to, but not necessarily exactly the same as, the usual written abbreviation for a given unit. These unit-codes are displayed in ...

3. Crop factor - Wikipedia

   en.wikipedia.org/wiki/Crop_factor

   The most commonly used definition of crop factor is the ratio of a 35 mm frame's diagonal (43.3 mm) to the diagonal of the image sensor in question; that is, = /. Given the same 3:2 aspect ratio as 35mm's 36 mm × 24 mm area, this is equivalent to the ratio of heights or ratio of widths; the ratio of sensor areas is the square of the crop factor.

4. Concentric reducer - Wikipedia

   en.wikipedia.org/wiki/Concentric_reducer

   A concentric reducer is used to join pipe sections or tube sections on the same axis. [1] The concentric reducer is cone -shaped, and is used when there is a shift in diameter between pipes. [ 1 ] For example, when a 1" pipe transitions into a 3/4" pipe and the top or bottom of the pipe doesn't need to remain level. [ 2 ]

5. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

6. Engineering tolerance - Wikipedia

   en.wikipedia.org/wiki/Engineering_tolerance

   For example, if a shaft with a nominal diameter of 10 mm is to have a sliding fit within a hole, the shaft might be specified with a tolerance range from 9.964 to 10 mm (i.e., a zero fundamental deviation, but a lower deviation of 0.036 mm) and the hole might be specified with a tolerance range from 10.04 mm to 10.076 mm (0.04 mm fundamental ...

7. Help:Convert units - Wikipedia

   en.wikipedia.org/wiki/Help:Convert_units

   Metric prefixes; Text Symbol Factor or; yotta Y 10 24: 1 000 000 000 000 000 000 000 000: zetta Z 10 21: 1 000 000 000 000 000 000 000: exa E 10 18: 1 000 000 000 000 000 000: peta P 10 15: 1 000 000 000 000 000: tera T

8. Eccentric reducer - Wikipedia

   en.wikipedia.org/wiki/Eccentric_reducer

   Eccentric reducers are used at the suction side of pumps to ensure air does not accumulate in the pipe. The gradual accumulation of air in a concentric reducer could result in a large bubble that could eventually cause the pump to stall or cause cavitation when drawn into the pump. Eccentric reducers exhibit a unique design with one side having ...

9. Flange focal distance - Wikipedia

   en.wikipedia.org/wiki/Flange_focal_distance

   Diagram illustrating the flange focal length of an SLR–type and a mirrorless–type camera. For an interchangeable lens camera, the flange focal distance (FFD) (also known as the flange-to-film distance, flange focal depth, flange back distance (FBD), flange focal length (FFL), back focus [1] or register, depending on the usage and source) of a lens mount system is the distance from the ...