Ads
related to: 2.4 inches in fraction table printablegenerationgenius.com has been visited by 100K+ users in the past month
- Loved by Teachers
Check out some of the great
feedback from teachers & parents.
- K-8 Standards Alignment
Videos & lessons cover most
of the standards for every state
- Grades K-2 Math Lessons
Get instant access to hours of fun
standards-based K-2 videos & more.
- Grades 6-8 Math Lessons
Get instant access to hours of fun
standards-based 6-8 videos & more.
- Loved by Teachers
hand2mind.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
4.2333 mm. The pica is a typographic unit of measure corresponding to approximately 1⁄6 of an inch, or from 1⁄68 to 1⁄73 of a foot. One pica is further divided into 12 points. In printing, three pica measures are used: The French pica of 12 Didot points (also called cicero) generally is: 12 × 0.376 = 4.512 mm (0.1776 in).
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
A fraction is applied to the output unit (if there is only one), or to non-SI units (if using a combination), except that if a precision is also specified, the fraction only applies to the hand unit. {{convert|18.45|in|m|frac=2}} → 18.45 inches ( 1 ⁄ 2 m)
Sizes are often expressed as a fraction of an inch, with a one in the numerator, and a decimal number in the denominator. For example, 1/2.5 converts to 2/5 as a simple fraction, or 0.4 as a decimal number. This "inch" system gives a result approximately 1.5 times the length of the diagonal of the sensor.
A good example of this a 4×6 print (6 inch wide by 4 inch tall landscape) perfectly matches the 3:2 aspect ratio of a DSLR/35 mm, since 6/2=3 and 4/2=2. For analog projection of photographic slides, projector and screen use a 1:1 aspect ratio, supporting horizontal and vertical orientation equally well.
Rack units are typically denoted without a space between the number of units and the 'U'. Thus, a 4U server enclosure (case) is seven inches (177.8 mm) high, or more practically, built to occupy a vertical space seven inches high, with sufficient clearance to allow movement of adjacent hardware.
Ads
related to: 2.4 inches in fraction table printablegenerationgenius.com has been visited by 100K+ users in the past month
hand2mind.com has been visited by 10K+ users in the past month