enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Trap primer - Wikipedia

   en.wikipedia.org/wiki/Trap_primer

   A trap primer (or trap seal primer) is a plumbing device or valve that adds water to traps.The water seals in traps are needed to prevent sewer gases from entering buildings, but because this water is exposed to the air, it is subject to evaporation over time in infrequently used floor drains, leading to the release of sewer gas into the environment.

3. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   A drain-waste-vent system (or DWV) is the combination of pipes and plumbing fittings that captures sewage and greywater within a structure and routes it toward a water treatment system. It includes venting to the exterior environment to prevent a vacuum from forming and impeding fixtures such as sinks, showers, and toilets from draining freely ...

4. Floor drain - Wikipedia

   en.wikipedia.org/wiki/Floor_drain

   A floor drain is a plumbing fixture that is installed in the floor of a structure, mainly designed to remove any standing water near it. They are usually round, but can also be square or rectangular. They usually range from 2 to 12 inches (5.1 to 30.5 cm); most are 4 inches (10 cm) in diameter. They have gratings that are made of metal or plastic.

5. Plug (sanitation) - Wikipedia

   en.wikipedia.org/wiki/Plug_(sanitation)

   A plug in sanitation is an object that is used to close a drainage outlet firmly. The insertion of a plug into a drainage outlet allows the container to be filled with water or other fluids. In contrast to screw on caps, plugs are pushed into the hole and are not put over the hole. Plugs are most commonly encountered in the bathroom or kitchen ...

6. Trap (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Trap_(plumbing)

   Trap (plumbing) Water seal in drain pipe under a sink. Water enters at right, fills the trap, and continues left. Inverted siphoning occurs below the line "A". In plumbing, a trap is a U-shaped portion of pipe designed to trap liquid or gas to prevent unwanted flow; most notably sewer gases from entering buildings while allowing waste materials ...

7. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Copper fittings for soldered joints. Pipe fittings: 1) Copper (solder); 2) Iron or brass (threaded); 3) Brass (compression); 4) Brass (compression to solder); 5) Brass adapters. PVC fittings. A fitting or adapter is used in pipe systems to connect sections of pipe (designated by nominal size, with greater tolerances of variance) or tube ...