Search results
Results from the WOW.Com Content Network
A push-button (also spelled pushbutton) or simply button is a simple switch mechanism to control some aspect of a machine or a process. Buttons are typically made out of hard material, usually plastic or metal. [1] The surface is usually flat or shaped to accommodate the human finger or hand, so as to be easily depressed or pushed.
In computer systems programming, an interrupt handler, also known as an interrupt service routine or ISR, is a special block of code associated with a specific interrupt condition. Interrupt handlers are initiated by hardware interrupts, software interrupt instructions, or software exceptions , and are used for implementing device drivers or ...
If push–pull output was mistakenly used instead, the active device attempting to set the line voltage low would be in competition with the other devices attempting to set the line voltage high, which would result in unpredictable output and heat. SCSI-1 devices use open collector for electrical signaling. [9] SCSI-2 and SCSI-3 may use EIA-485.
SPI subs sometimes use an out-of-band signal (another wire) to send an interrupt signal to a main. Examples include pen-down interrupts from touchscreen sensors, thermal limit alerts from temperature sensors , alarms issued by real-time clock chips, SDIO [ note 7 ] and audio jack insertions for an audio codec .
Message Signaled Interrupts (MSI) are a method of signaling interrupts, using special in-band messages to replace traditional out-of-band signals on dedicated interrupt lines. While message signaled interrupts are more complex to implement in a device, they have some significant advantages over pin-based out-of-band interrupt signalling, such ...
A well-designed and succinct interrupt handler or interrupt service routine (ISR) will not only expeditiously service any event that causes an interrupt, it will do so without interfering in any way with the interrupted foreground task—the ISR must be "transparent" to the interrupted task (although exceptions may apply in specialized cases ...
An interrupt control register, or ICR, is a hardware register in a computer chip used to configure the chip to generate interrupts—to raise a signal on an interrupt line—in response to some event occurring within the chip or a circuit connected to the chip.
A hardware interrupt is a condition related to the state of the hardware that may be signaled by an external hardware device, e.g., an interrupt request (IRQ) line on a PC, or detected by devices embedded in processor logic (e.g., the CPU timer in IBM System/370), to communicate that the device needs attention from the operating system (OS) [7] or, if there is no OS, from the bare metal ...