Search results
Results from the WOW.Com Content Network
For AC-operated devices (e.g. coaxial cable, loudspeakers), there may even be two power ratings, a maximum (peak) power rating and an average power rating. [5] [6] For such devices, the peak power rating usually specifies the low frequency or pulse energy, while the average power rating limits high-frequency operation. [5]
In some cases, an audio device may be measured by the total system power of all its loudspeakers by adding all their peak power ratings. Many home theater in a box systems are rated this way. Often low-end home theater systems' power ratings are taken at a high level of harmonic distortion as well; as high as 10%, which would be noticeable. [21]
High power LED current (peak 2.7 A) [5] 5 A One typical 12 V motor vehicle headlight (typically 60 W) 9 A 230 V AC, toaster, kettle (2 kW) 10 1: 10 or 20 A 230 V AC, Europe common domestic circuit breaker rating 15 or 20 A 120 V AC, United States, Canada and Mexico domestic circuit breaker rating 16.6 A 120 V AC, toaster, kettle (2 kW) 20 A
Modern Class AB amplifiers commonly have peak efficiencies between 30 and 55% in audio systems and 50-70% in radio frequency systems with a theoretical maximum of 78.5%. Commercially available Class D switching amplifiers have reported efficiencies as high as 90%. Amplifiers of Class C-F are usually known to be very high-efficiency amplifiers.
The frequency range often specified for audio components is between 20 Hz to 20 kHz, which broadly reflects the human hearing range. Well-designed solid-state amplifiers and CD players may have a frequency response that varies by only 0.2 dB between 20 Hz to 20 kHz. [4]
Unlike average power, which is the mean power output over a period, peak power represents the maximum power output at any given instant. This distinction is crucial in applications where signal peaks can significantly exceed the average power level. Peak power is a critical parameter in the field of radio frequency (RF) and telecommunications.
The peak-to-average power ratio (PAPR) is the peak amplitude squared (giving the peak power) divided by the RMS value squared (giving the average power). [1] It is the square of the crest factor. When expressed in decibels , crest factor and PAPR are equivalent, due to the way decibels are calculated for power ratios vs amplitude ratios .
It should not be confused with "half-power" bandwidth, only used in conjunction with filter frequency response curves, where it refers to -3dB points in the frequency response of a band-pass filter. Data sheets for operational amplifiers often use the term (full-)power bandwidth to indicate the highest frequency at which the achievable peak-to ...