Search results
Results from the WOW.Com Content Network
The rate at which sedimentation occurs is an important characteristic of the decanter centrifuge separation process. The sedimentation rate is influenced by the particle size, the shapes of the particles, their density differential between solid and liquid and the viscosity of the liquid. This process characteristic can be improved by utilizing ...
The surface loading rate (also known as surface overflow rate or surface settling rate) for a lamella clarifier falls between 10 and 25 m/h. For these settling rates, the retention time in the clarifier is low, at around 20 minutes or less, [ 7 ] with operating capacities tending to range from 1–3 m 3 /hour/m 2 (of projected area).
The tested material is considered as an ideal material for the solid bowl centrifuge if the volume of solids and the volume of compaction come together within 90–120 seconds with a clear effluent. [13] The spinning of difficult material may require higher G force, i.e. 2500 x G. [13]
The sedimentation coefficient has units of time, expressed in svedbergs. One svedberg is 10 −13 s. The sedimentation coefficient normalizes the sedimentation rate of a particle to its applied acceleration. The result no longer depends on acceleration, but only on the properties of the particle and the fluid in which it is suspended.
Economy favors using small tanks; but if flow rate through the tank is too high, most particles will not have sufficient time to settle, and will be carried with the treated water. Considerable attention is focused on reducing water inlet and outlet velocities to minimize turbulence and promote effective settling throughout available tank volume.
A laboratory ultracentrifuge. In chemistry, a Svedberg unit or svedberg (symbol S, sometimes Sv [a]) is a non-SI metric unit for sedimentation coefficients.The Svedberg unit offers a measure of a particle's size indirectly based on its sedimentation rate under acceleration (i.e. how fast a particle of given size and shape settles out of suspension). [1]
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
Elutriation is a process for separating particles based on their size, shape and density, using a stream of gas or liquid flowing in a direction usually opposite to the direction of sedimentation. This method is mainly used for particles smaller than 1 μm.