Search results
Results from the WOW.Com Content Network
Code points located at U+10000 or higher must be denoted with the \U syntax, whereas lower code points may use \u or \U. The code point is converted into a sequence of code units in the encoding of the destination type on the target system. For example, where the encoding is UTF-8, and UTF-16 for wchar_t:
A VLAN access control list (VACL) provides access control for all packets that are bridged within a VLAN or that are routed into or out of a VLAN. Unlike regular Cisco IOS access control lists that are configured on router interfaces and applied on routed packets only, VACLs apply to all packets.
Python uses the following syntax to express list comprehensions over finite lists: S = [ 2 * x for x in range ( 100 ) if x ** 2 > 3 ] A generator expression may be used in Python versions >= 2.4 which gives lazy evaluation over its input, and can be used with generators to iterate over 'infinite' input such as the count generator function which ...
IP-in-IP IP in IP (encapsulation) RFC 2003: 0x05 5 ST Internet Stream Protocol: RFC 1190, RFC 1819: 0x06 6 TCP Transmission Control Protocol: RFC 793: 0x07 7 CBT Core-based trees: RFC 2189: 0x08 8 EGP Exterior Gateway Protocol: RFC 888: 0x09 9 IGP Interior gateway protocol (any private interior gateway, for example Cisco's IGRP) 0x0A 10 BBN-RCC-MON
In computer security, an access-control list (ACL) is a list of permissions [a] associated with a system resource (object or facility). An ACL specifies which users or system processes are granted access to resources, as well as what operations are allowed on given resources. [1] Each entry in a typical ACL specifies a subject and an operation.
An extension to the CAN bus standard (CAN 2.0 B) allows extended frame ids of 29 bits, but in practice CANopen networks big enough to need the extended id range are rarely seen. In CANopen the 11-bit id of a CAN-frame is known as communication object identifier, or COB-ID.
Longest prefix match (also called Maximum prefix length match) refers to an algorithm used by routers in Internet Protocol (IP) networking to select an entry from a routing table. [1] Because each entry in a forwarding table may specify a sub-network, one destination address may match more than one forwarding table entry. The most specific of ...
It should be possible to define a new operation for (some) classes of an object structure without changing the classes. When new operations are needed frequently and the object structure consists of many unrelated classes, it's inflexible to add new subclasses each time a new operation is required because "[..] distributing all these operations across the various node classes leads to a system ...