Search results
Results from the WOW.Com Content Network
for AC having a supply frequency of 50, 60 or 400Hz, though the use of other frequencies for special purposes is not excluded. This includes low-voltage installations, as found in most domestic and commercial properties, and extra-low-voltage systems, but excludes high voltage , as found in generation, transmission and distribution networks.
Waveform and phase sequence are fixed by the construction of the generator and its connections to the system. During installation of a generator, careful checks are made to ensure the generator terminals and all control wiring is correct so that the order of phases (phase sequence) matches the system.
Household wiring does not usually use three-phase supplies and the clash only occurs in three-phase systems. Wiring to the old standard can be detected by use of a red wire. The new standard colour code does not use red. Where new wiring is mixed with old, cables must be clearly marked to prevent interchange of phase and neutral.
Installing electrical wiring by "chasing" grooves into the masonry structure of the walls of a building. Materials for wiring interior electrical systems in buildings vary depending on: Intended use and amount of power demand on the circuit; Type of occupancy and size of the building; National and local regulations
A schematic representation of long distance electric power transmission. From left to right: G=generator, U=step-up transformer, V=voltage at beginning of transmission line, Pt=power entering transmission line, I=current in wires, R=total resistance in wires, Pw=power lost in transmission line, Pe=power reaching the end of the transmission line, D=step-down transformer, C=consumers.
Schematic representation of measurement categories. Measurement category is a method of classification by the International Electrotechnical Commission (IEC) [1] of live electric circuits used in measurement and testing of installations and equipment, usually in the relation within a building (residential or industrial).
Its reduction with increasing frequency, as the ratio of skin depth to the wire's radius falls below about 1, is plotted in the accompanying graph, and accounts for the reduction in the telephone cable inductance with increasing frequency in the table below. The internal component of a round wire's inductance vs. the ratio of skin depth to radius.
A residual-current device (RCD), residual-current circuit breaker (RCCB) or ground fault circuit interrupter (GFCI) [a] is an electrical safety device, more specifically a form of Earth-leakage circuit breaker, that interrupts an electrical circuit when the current passing through line and neutral conductors of a circuit is not equal (the term residual relating to the imbalance), therefore ...