Search results
Results from the WOW.Com Content Network
The Sydney Coordinated Adaptive Traffic System, abbreviated SCATS, is an intelligent transportation system that manages the dynamic (on-line, real-time) timing of signal phases at traffic signals, meaning that it tries to find the best phasing (i.e. cycle times, phase splits and offsets) for a traffic situation (for individual intersections as well as for the whole network).
A simple power entry module, the rectangular device below a red power switch in the photograph. This example consists of an IEC 60320 C14 inlet connector and fuse holder. The fuse is protected by a sliding plastic cover, which requires the power lead to be removed before it can be opened.
The SAE J2716 SENT (Single Edge Nibble Transmission) protocol [1] is a point-to-point scheme for transmitting signal values from a sensor to a vehicle controller. It is intended to allow for transmission of high resolution data with a low system cost.
A PTO at the rear end of a farm tractor A PTO (in the box at the bottom) in the center of the three-point hitch of a tractor. A power take-off or power takeoff (PTO) is one of several methods for taking power from a power source, such as a running engine, and transmitting it to an application such as an attached implement or separate machine.
The Regional Transport Office or District Transport Office or Regional Transport Authority (RTO/DTO/RTA) is an office administered by the State Governments constituted under Section 213 (1) of the Motor Vehicles Act, 1988 of India and is responsible for implementing the various provisions of this Act. It operates under the Transport Department ...
Road signs in United Arab Emirates are modelled on the British road sign system [1]: 433 that are regulated by the Roads and Transport Authority (RTA) Dubai and Department of Transport (DoT) Abu Dhabi.
An installation manual or installation guide is a technical communication document intended to instruct people how to install a particular product. An installation manual is usually written by a technical writer or other technical staff. Installation is the act of putting something in place so that it is ready for use. [1]
Pneumatic level sensors are used where hazardous conditions exist, where there is no electric power or its use is restricted, or in applications involving heavy sludge or slurry. As the compression of a column of air against a diaphragm is used to actuate a switch, no process liquid contacts the sensor's moving parts. These sensors are suitable ...