Search results
Results from the WOW.Com Content Network
In-circuit emulation (ICE) is the use of a hardware device or in-circuit emulator used to debug the software of an embedded system. It operates by using a processor with the additional ability to support debugging operations, as well as to carry out the main function of the system.
Background debug mode (BDM) interface is an electronic interface that allows debugging of embedded systems. Specifically, it provides in-circuit debugging functionality in microcontrollers. It requires a single wire and specialized electronics in the system being debugged.
Key Nexus functionality involves either JTAG-style request/response interactions, or packets transferred through the debug port, and includes: Run-time control... With all implementations, debug tools can start and stop the processor, modify registers, and single-step machine instructions. Memory access... Nexus supports memory access while the ...
Debug Card Interface (Enables repair centers to monitor the boot process with a special device in an attempt to fix problems) SCI from the Embedded Controller to inform the ACPI driver (in the OS) of an ACPI Event; As a core system component, the embedded controller is always on when power is supplied to the mainboard.
ST-LINK/V2 by STMicroelectronics [61] The ST-LINK/V2 debugger embedded on STM32 Nucleo and Discovery development boards can be converted to SEGGER J-LINK protocol. [62] TRACE32 Debugger and ETM/ITM Trace by Lauterbach. [63] ULINK by Keil. [64] Debugging tools and/or debugging plug-ins (in alphabetical order): GNU ARM Eclipse J-LINK Debugging ...
The ICE is supported by the Microchip Studio IDE, as well as a command line interface (atprogram). The Atmel-ICE supports a limited implementation of the Data Gateway Interface (DGI) when debugging and programming features are not in use. The Data Gateway Interface is an interface for streaming data from a target device to the connected computer.
Allinea DDT — graphical debugger for debugging multithreaded and multiprocess applications on Linux platforms; AQtime — profiler and memory/resource debugger for Windows; ARM Development Studio 5 (DS-5) CA/EZTEST — was a CICS interactive test/debug software package; CodeView — was a debugger for the DOS platform
debugWIRE is activated by setting (programming to zero) of the fuse DWEN (debugWIRE enable), normally located in the high fuse byte. After this action the /RESET pin function isn't available anymore and the ISP protocol cannot be used. debugWIRE can be disabled with any of the mentioned debuggers by sending a special reset command that disables temporarily the debugWIRE function and reenables ...