Search results
Results from the WOW.Com Content Network
When the MIL is lit, the engine control unit stores a fault code related to the malfunction, which can be retrieved—although in many models this requires the use of a scan tool. This warning light can indicate almost anything from a loose gas cap to a serious knock or fault in the engine.
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
Stuck throttle (unrelated to pedal position) [12] [13] Shorting of tin whiskers [14] [15] Diesel engine runaway: Diesel engine power is governed by the amount of fuel supplied. Excessive pressure in the crankcase can force mist of engine oil into the intake manifold, which can be burned in the same fashion as Diesel fuel, thus causing runaway.
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.
In fuel injected engines, the throttle body is the part of the air intake system that controls the amount of air flowing into the engine, in response to driver accelerator pedal input in the main. The throttle body is usually located between the air filter box and the intake manifold, and it is usually attached to, or near, the mass airflow sensor.
The advent of concern about fuel economy and emissions had major impacts on engine design. Some of the trade-offs reduced throttle response. Most new cars employ a drive-by-wire system, which includes electronic throttle control and can itself either reduce or increase throttle response (Depending on whether or not it's being employed on a performance car).
The closed throttle provides engine braking by forcing the engine to generate a vacuum between the throttle and the cylinders. Typically, the controls for a compression brake consist of an on/off switch and often a selector that controls the number of cylinders on which the brake is active. Throttle and clutch switches are integral with the system.