Search results
Results from the WOW.Com Content Network
A sailor checks the outside diameter of a shear pin in the machinery repair shop aboard US aircraft carrier John C. Stennis. A shear pin is a mechanical detail designed to allow a specific outcome to occur once a predetermined force is applied. It can either function as a safeguard designed to break to protect other parts, or as a conditional ...
A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1] At the bottom, the hold down is connected to the concrete foundation or structural slab by an embedded or epoxied anchor bolt. At the top, the hold down is connected to a ...
Tilt-up, tilt-slab or tilt-wall is a type of building and a construction technique using concrete. Though it is a cost-effective technique with a shorter completion time, [ 1 ] poor performance in earthquakes has mandated significant seismic retrofit requirements in older buildings.
Anchor bolts transfer different types of load: tension forces and shear forces. [3] A connection between structural elements can be represented by steel columns attached to a reinforced concrete foundation. [4] A common case of a non-structural element attached to a structural one is the connection between a facade system and a reinforced ...
the collector (or membrane), used as a shear panel to carry in-plane shear; The drag strut member, used to transfer the load to the shear walls or frames; the chord, used to resist the tension and compression forces that develop in the diaphragm since the collector is usually incapable of handling these loads alone
Shear (and tension) loads can be transferred between two structural elements by either a bearing-type connection or a slip-critical connection. In a slip-critical connection, loads are transferred from one element to another through friction forces developed between the faying surfaces of the connection. These friction forces are generated by ...
The tieback-deadman structure resists forces that would otherwise cause the wall to lean, as for example, when a seawall is pushed seaward by water trapped on the landward side after a heavy rain. Tiebacks are drilled into soil using a small diameter shaft, and usually installed at an angle of 15 to 45 degrees.
The derivation of the maximum arching moment of resistance of laterally restrained concrete bridge deck slabs utilised Rankin's [21] idealised elastic-plastic stress-strain criterion for concrete, valid for concrete cylinder strengths up to at least 70N/mm 2, which he had derived on the basis of Hognestad, Hanson and McHenry's [23] ultimate ...