Search results
Results from the WOW.Com Content Network
A track circuit interrupter may be fitted at catch points, trap points or buffer stops to maintain a track circuit in the 'occupied' state in the event of a derailment. The track circuit remains de-energised until the interrupter is replaced. GK/RT0011 specifies the requirements for the provision of track circuit interrupters. [1]
D-ATC indicator used on the E233 series trains. The digital ATC system uses the track circuits to detect the presence of a train in the section and then transmits digital data from wayside equipment to the train on the track circuit numbers, the number of clear sections (track circuits) to the next train ahead, and the platform that the train will arrive at.
The first time T-TRAK builder is advised to use Kato Unitrack exclusively on their first few modules. Track Section Lengths for Modules of Various Lengths. The use of Kato track created an early "informal" standard for the length of track on a module to be 310mm (which is 12.2"). A module of this size is typically referred to as a "single".
Automatic block signaling (ABS), spelled automatic block signalling or called track circuit block (TCB [1]) in the UK, is a railroad communications system that consists of a series of signals that divide a railway line into a series of sections, called blocks. The system controls the movement of trains between the blocks using automatic signals.
Signalling block systems enable the safe and efficient operation of railways by preventing collisions between trains. The basic principle is that a track is broken up into a series of sections or "blocks". Only one train may occupy a block at a time, [citation needed] and the blocks are sized to allow a train to stop within them. [1]
A buffer stop, bumper, bumping post, bumper block or stopblock (US), is a device to prevent railway vehicles from going past the end of a physical section of track. The design of the buffer stop is dependent, in part, on the kind of couplings that the railway uses, since the coupling gear is the first part of the vehicle that the buffer stop ...
Most blocks are "fixed", i.e. they include the section of track between two fixed points. On timetable, train order, and token-based systems, blocks usually start and end at selected stations. On signalling-based systems, blocks start and end at signals. The lengths of blocks are designed to allow trains to operate as frequently as necessary.
In inductive system, data is transmitted magnetically between the track and locomotive by magnets mounted beside the rails and on the locomotive. [4]In the Integra-Signum system the trains are influenced only at given locations, for instance whenever a train ignores a red signal, the emergency brakes are applied and the locomotive's motors are shut down.