enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Router (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Router_(woodworking)

   The set up includes an air or electric driven router, a cutting tool often referred to as a router bit, and a guide template. Also the router can be fixed to a table or connected to radial arms which can be controlled more easily. In general there are three types of cutting bits or tools. Fluted cutters (used for edging and trimming)

3. Tipped tool - Wikipedia

   en.wikipedia.org/wiki/Tipped_tool

   The advantage of tipped tools is only a small insert of the cutting material is needed to provide the cutting ability. The small size makes manufacturing of the insert easier than making a solid tool of the same material. This also reduces cost because the tool holder can be made of a less-expensive and tougher material.

4. Dado (joinery) - Wikipedia

   en.wikipedia.org/wiki/Dado_(joinery)

   A through [1] dado involves cuts which run between both edges of the surface, leaving both ends open. A stopped or blind [2] dado ends before one (stopped) or both (blind) of the cuts meets the edge of the surface. [1] A half dado is formed with a narrow dado cut into one part, coupled with a rabbet of another piece. This joint tends to be used ...

5. Router table (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Router_table_(woodworking)

   Router tables are used in one of three ways. In all cases, an accessory is used to direct the workpiece. A fence is used, with the router bit partially emerging from the fence. The workpiece is then moved against the fence, and the exposed portion of the router bit removes material from the workpiece. No fence is used.

6. Dado set - Wikipedia

   en.wikipedia.org/wiki/Dado_set

   As the dado set spins, the two outside blades cut the dado walls and the chippers remove the waste material in between and smooth the bottom of the dado. The chippers are added or removed to the set as required to make a dado of the desired width. Chippers can also be interspersed with spacers to finely adjust the dado width. Consequently ...

7. Cemented carbide - Wikipedia

   en.wikipedia.org/wiki/Cemented_carbide

   Mining and tunneling cutting tools are most often fitted with cemented carbide tips, the so-called "button bits". Artificial diamond can replace the cemented carbide buttons only when conditions are ideal, but as rock drilling is a tough job cemented carbide button bits remain the most used type throughout the world.