Search results
Results from the WOW.Com Content Network
The density of gases changes with even slight variations in temperature, while densities of liquid and solids, which are generally thought of as incompressible, will change very little. Specific volume is the inverse of the density of a substance; therefore, careful consideration must be taken account when dealing with situations that involve ...
The increase in weight is equal to the amount of liquid displaced by the object, which is the same as the volume of the suspended object times the density of the liquid. [ 1 ] The concept of Archimedes' principle is that an object immersed in a fluid is buoyed up by a force equal to the weight of the fluid displaced by the object. [ 2 ]
The effect of pressure and temperature on the densities of liquids and solids is small. The compressibility for a typical liquid or solid is 10 −6 bar −1 (1 bar = 0.1 MPa) and a typical thermal expansivity is 10 −5 K −1. This roughly translates into needing around ten thousand times atmospheric pressure to reduce the volume of a ...
This device enables a liquid's density to be measured accurately by reference to an appropriate working fluid, such as water or mercury, using an analytical balance. [citation needed] If the flask is weighed empty, full of water, and full of a liquid whose relative density is desired, the relative density of the liquid can easily be calculated.
A vapor can exist in equilibrium with a liquid (or solid), in which case the gas pressure equals the vapor pressure of the liquid (or solid). A supercritical fluid (SCF) is a gas whose temperature and pressure are above the critical temperature and critical pressure respectively. In this state, the distinction between liquid and gas disappears.
In the pressure-temperature phase diagram (Fig. 1) the boiling curve separates the gas and liquid region and ends in the critical point, where the liquid and gas phases disappear to become a single supercritical phase. The appearance of a single phase can also be observed in the density-pressure phase diagram for carbon dioxide (Fig. 2).
Liquefied petroleum gas, also referred to as liquid petroleum gas (LPG or LP gas), is a fuel gas which contains a flammable mixture of hydrocarbon gases, specifically propane, n-butane and isobutane. It can sometimes contain some propylene , butylene , and isobutene .
U-tube with piezo-electric actuator Digital density measuring principle. The oscillating U-tube is a technique to determine the density of liquids and gases based on an electronic measurement of the frequency of oscillation, from which the density value is calculated. This measuring principle is based on the Mass-Spring Model.