Search results
Results from the WOW.Com Content Network
The Intel RAID ROM is the firmware in the motherboard BIOS that is used to create the RAID array. Note: The RST drivers can be used for RAID and also on a single drive as it contains an AHCI driver. There is a bug in the version 12.5.0.1066 RST driver, which cause TRIM commands not to pass through the RAID driver to the drives.
RAID (/ r eɪ d /; redundant array of inexpensive disks or redundant array of independent disks) [1] [2] is a data storage virtualization technology that combines multiple physical data storage components into one or more logical units for the purposes of data redundancy, performance improvement, or both.
It often implements hardware RAID, thus it is sometimes referred to as RAID controller. It also often provides additional disk cache . Disk array controller is often ambiguously shortened to disk controller which can also refer to the circuitry responsible for managing internal disk drive operations.
Diagram of a RAID 1 setup. RAID 1 consists of an exact copy (or mirror) of a set of data on two or more disks; a classic RAID 1 mirrored pair contains two disks.This configuration offers no parity, striping, or spanning of disk space across multiple disks, since the data is mirrored on all disks belonging to the array, and the array can only be as big as the smallest member disk.
It may also be necessary to load chipset-specific AHCI or RAID drivers at installation time, for example from a USB flash drive). On Windows Vista and Windows 7, this can be fixed by configuring the msahci device driver to start at boot time (rather than on-demand).
ICH - 82801AA. The first version of the ICH was released in June 1999 along with the Intel 810 northbridge.While its predecessor, the PIIX, was connected to the northbridge through an internal PCI bus with a bandwidth of 133 MB/s, the ICH used a proprietary interface (called by Intel Hub Interface) that linked it to the northbridge through an 8-bit wide, 266 MB/s bus.
Support for 4 SATA and 4 PATA drives, which can be linked together in any combination of SATA and PATA to form a RAID 0, 1, or 0+1. Nvidia RAID Morphing, which allows conversion from one RAID type to another on the fly. Nvidia nTune, a tool for easy overclocking and timing configurations. Full 1000 MHz speed on HyperTransport (8 GB/s transfer ...
The RAIDXpert is a remote RAID configuration tool, for changing the RAID level of the RAID setup connected via SATA 3.0 Gbit/s ports (connected to SB600, excluding extra SATA 3.0 Gbit/s ports through additional SATA chip on some motherboard implementations), including RAID 0, RAID 1, and RAID 0+1.